User manual KONICA MINOLTA MAGICOLOR 2300 DL

[. . . ] magicolor 2300 DL User's Guide ® 1800724-001A Thank You Thank you for purchasing a KONICA MINOLTA printer. Trademarks The KONICA MINOLTA and KONICA MINOLTA logo are trademarks or registered trademarks of KONICA MINOLTA HOLDINGS, INC. magicolor is a trademarks or registered trademarks of KONICA MINOLTA PRINTING SOLUTIONS U. S. A. , INC. Other trademarks and registered trademarks are the propery of their respective owners. Acrobat ® Reader Copyright © 1987-2002 Adobe Systems Incorporated. [. . . ] For more details, refer to "Media Rollers" on page 75. 96 Solving Problems with Media Jams Solving Other Problems Symptom Cause Solution Printer The power cord is not Turn the power switch off (O position), power is not correctly plugged into then remove the power cord from the on. Something is wrong with the outlet connected to the printer. The power switch is not correctly turned on (I position). Plug another electrical appliance into the outlet and see whether it operates properly. Set the power switch to the off (O) position, then set it back to the on (I) position. The printer is Use a power source with the connected to an specifications listed in appendix A, outlet with a voltage "Technical Specifications. " or frequency that does not match the printer specifications. Data was An error message is sent to the displayed in the printer, but it message window. The control panel displays Handle according to the message displayed. TONER LOW much sooner than expected You can't print a configuration page. A high-capacity toner In the ENGINE/CHANGE TONER SZ cartridge was loaded, menu, select the capacity listed on the but the toner size was toner cartridge label. The toner cartridge is Remove the toner cartridge and check defective. If it is damaged, replace it (Engine/Replace Toner menu). The printer's doors aren't closed securely. Check that the media trays are loaded with media, in place, and secure. Make sure the doors are closed securely. Close all doors gently to avoid jarring the printer. Make sure the waste toner bottle in installed correctly. There is a media jam. Check for a media jam. Solving Other Problems 97 Symptom Printing takes too much time. Cause The printer is set to a slow printing mode (for example, thick stock or transparency). The printer is set to power saving mode. The job is very complex. Solution It takes more time to print with special media. When using regular paper, make sure that the media type is set properly in the driver. It takes time for printing to start in power saving mode. If you do not want to use this mode, disable it. No action needed. The printer memory is Add more memory. Blank pages come out during a printing job. [. . . ] The result could be an electric shock or a fire. Remove from the power cord from the socket with wet hands as this may result in an electric shock. Place any heavy objects on the power cord. Do not pull or kink the cord as this can result in damage to the cord. [. . . ]