User manual KONICA MINOLTA MAGICOLOR 2500W

[. . . ] magicolor 2500W User's Guide ® A00V-9563-01A 1800816-001B Thank You Thank you for purchasing a magicolor 2500W. Your magicolor 2500W is specially designed for optimal performance in Windows environments. Trademarks KONICA MINOLTA and the KONICA MINOLTA logo are trademarks or registered trademarks of KONICA MINOLTA HOLDINGS, INC. magicolor is a trademark or registered trademark of KONICA MINOLTA PRINTING SOLUTIONS U. S. A. , INC. Copyright Notice Copyright © 2006 KONICA MINOLTA BUSINESS TECHNOLOGIES, INC. , Marunouchi Center Building, 1-6-1 Marunouchi, Chiyoda-ku, Tokyo, 100-0005, Japan. This document may not be copied, in whole or part, nor transferred to any other media or language, without written permission of KONICA MINOLTA BUSINESS TECHNOLOGIES, INC. Notice KONICA MINOLTA BUSINESS TECHNOLOGIES, INC. [. . . ] If the Auto Toner Replace check box has been selected in Mode Setting of the Status Display, closing the top cover after replacing the toner cartridge automatically moves the next empty toner cartridge so that it can be replaced. If there are no more empty toner cartridges, the printer warms up, then is automatically reset to be ready to print. Press the Cancel key to reset the printer and clear the indicator message. If no operation is performed for 30 seconds after the top cover is closed, the printer automatically resets. The printer must complete a calibration cycle (less than 2 minutes) after a toner cartridge has been replaced. If you open a cover before the printer is reset, the calibration stops, then starts over again after the cover is closed. 13 52 Replacing Consumables Replacing the Drum Cartridge 1 Pull the lever, and then open the top cover. If there is paper in the output tray, remove it, and then fold up the output tray before opening the top cover. Do not touch the transfer belt. 2 Carefully pull out the drum cartridge. Note Dispose of the used drum cartridge according to your local regulations. Do not burn the drum cartridge. Replacing Consumables 53 3 Prepare the new drum cartridge. Do not touch the PC drum on the drum cartridge. 4 Install the new drum cartridge. 5 Carefully close the top cover. 54 Replacing Consumables The printer must complete a calibration cycle (less than 2 minutes) after the drum cartridge has been replaced. If you open a cover before the printer is reset, the calibration stops, then starts over again after the cover is closed. Replacing Consumables 55 Maintaining the Printer Maintaining the Printer CAUTION Read all caution and warning labels carefully, making sure to follow any instructions contained in them. These labels are located on the inside of the printer's covers and the interior of the printer body. Handle the printer with care to preserve its life. Abuse may cause damage and void your warranty. If dust and paper scraps remain on the inside or outside of the printer, printer performance and print quality will suffer, so the printer should be cleaned periodically. Keep the following guidelines in mind. WARNING! Turn off the printer, unplug the power cord, and disconnect all interface cables before cleaning. Do not spill water or detergent into the printer; otherwise the printer will be damaged and an electric shock may occur. CAUTION The fuser unit is hot. When the right side cover is opened, the fuser unit temperature drops gradually (one hour wait time). Be careful when cleaning the inside of the printer or removing media misfeeds, as the fuser unit and other internal parts may be very hot. Do not place anything on top of the printer. Never spray cleaning solution directly on the printer's surface; the spray could penetrate through the air vents of the printer and damage the internal circuits. Avoid using abrasive or corrosive solutions or solutions that contain solvents (such as alcohol and benzene) to clean the printer. [. . . ] One or more of the toner cartridges are low or empty. Remove the toner cartridges and verify that the toner is distributed evenly on each cartridge roller, and reinstall the toner cartridges. If necessary, replace the specified toner cartridge. 88 Solving Problems with Printing Quality Symptom Colors are not registering properly; colors are mixed or have pageto-page variation. Cause Solution The drum cartridge is Remove the drum cartridge and reinnot correctly seated. One or more of the toner cartridges are defective. [. . . ]