User manual KONICA MINOLTA MAGICOLOR 330

[. . . ] QMS magicolor® / magicolor® Plus Printer User's Guide 1800364-001B Trademark Acknowledgements The following are trademarks or registered trademarks of their respective owners. Those listed as registered are registered in the United States Patent and Trademark Office. Some trademarks are also registered in other countries. Other product names mentioned in this manual may be trademarks or registered trademarks of their respective owners. [. . . ] Use only lint-free paper towels, cloths, or swabs. After cleaning, allow all parts to dry before closing the printer, reattaching the power cord, and turning on the power switch. Make sure any parts removed during cleaning are replaced before reconnecting the power cord and turning on the printer. s s s s 6-26 Consumables and Preventative Maintenance Chapter 6 Cleaning the Charger Unit Clean the charger unit whenever the print quality diminishes. To clean this unit you need several cotton cloths and swabs, and the wire cleaner located in the OPC belt tray (see figure 6. 11 for location). Open the manual feed tray by lightly pressing on the top-right corner (fig. 6. 10), and then tilt the tray out and down. Fig. 6. 10 Open the Manual Feed Tray CAUTION: The OPC belt is extremely sensitive to bright lights and direct sunlight. Limit exposure to 800 lux (the average fluorescent lighting in an office) of light to under 2 minutes. If exposure exceeds this, put the belt in a dark place to recover; depending on exposure, recovery may take up to 2 hours. Also, handle the OPC belt carefully, using either the two green side-handles or using the green end-handle when possible. It is Consumables and Preventative Maintenance 6-27 Chapter 6 extremely sensitive to hand oils and scratches both of which reduce print quality. When you must set it down, gently lay it on a clean, lint- and dirt-free surface, such as on fresh paper for the printer. Lift the OPC belt cartridge handle up to unlock it, and pull the cartridge straight out of the printer (fig. Remove the wire cleaner from the cartridge (fig. 6. 11 Remove the OPC Belt Cartridge 6-28 Consumables and Preventative Maintenance Chapter 6 4. Holding the cartridge by its edges, fold the green end-handle back down and set the cartridge up on that end. The cartridge will tilt slightly to one side. Locate the three brass-colored latches, which hold the charger unit in place. Then, swing each latch to the side to free the charger unit (fig. Grasp the green handle on the end of the charger unit and lift the unit out of the cartridge (fig. Then, place the OPC belt cartridge in its protective bag or a dark area to protect it from light and set it aside until you are ready to reinstall it. 5. 6. Fig. 6. 12 Open Charger Unit Brass Latches Consumables and Preventative Maintenance 6-29 Chapter 6 7. 8. Use clean, dry cotton cloths to gently wipe up any loose toner from the OPC belt cartridge area in the printer. [. . . ] 2-34, 6-11 Pressure-release pieces Moving the printer . 4-37 Printable region See Imageable region See Margins Printer Access . B-2 Index I-13 Electrical requirements . 6-41 Printer configuration Using applications. [. . . ]