User manual KONICA MINOLTA MAGICOLOR LX

[. . . ] QMS magicolor LX ® Printer User's Guide 1800409-001A The following are trademarks or registered trademarks of their respective owners. Those listed as registered are registered in the United States Patent and Trademark Office. Some trademarks are also registered in other countries. Other product names mentioned in this manual may be trademarks or registered trademarks of their respective owners. [. . . ] Die Fixiereinheit kann sehr heiß werden, so daß Verbrennungsgefahr besteht. Bitte lassen Sie die Fixiereinheit einige Zeit abkühlen, bevor Sie diese berühren. Pull open the spring latch on the outer edge of the oil-bottle retainer, and lift the retainer up and toward the center of the printer (fig. Grasp the top tab on the oil bottle, then lift the bottle out of the printer. The bottle may leak slightly, so place it in an 5. Consumables and Preventative Maintenance 6-19 Chapter 6 oil-proof container, such as a plastic bag, until you are ready to reinstall it after the move. NOTE: Normally, a little oil remains in the tray in which the oil bottle rests. If oil accidentally spills beyond this tray into the printer, use a clean, dry, lint-free cloth or some cotton swabs to wipe up the excess. Grasp the fuser unit by the two handles, one at each end (fig. 6. 6), and lift it up and out of the printer. Fig. 6. 6 Remove the Fuser Unit 6-20 Consumables and Preventative Maintenance Chapter 6 8. Align the fuser unit over an appropriate waste container, such as an old jar, and tilt the unit so the excess oil pours into the container (fig. Then, dispose of the oil following safety laws and regulations. Fig. 6. 7 Drain Oil from Fuser Unit 9. Use a clean, dry, lint-free cloth or some cotton swabs to wipe any remaining oil out of the tray. 10. Stuff a clean, wadded paper towel into the place normally occupied by the oil bottle to act as a cushion and to absorb any residual oil during the move. After the move, see "Replacing the Cleaning Pad and Oil Bottle, " earlier in this chapter, for instructions on reinstalling the oil bottle. Consumables and Preventative Maintenance 6-21 Chapter 6 Removing and Replacing Pressure-Release Pieces The pressure-release pieces help relieve the tension on the fuser rollers to protect the roller from accidental damage during a move (or prolonged storage). They must be installed for the move and removed again before printing. Illustrations of many of the steps described in this section are in "Removing the Pressure-Release Pieces" in chapter 2, "Initial Printer Setup. " Use the following procedure to remove and replace these pieces: 1. Open the paper exit unit by pulling up on the unit latch and then tilting the unit back and down (fig. Open the separator pawl unit by pulling back the two latches (one on each side) to unlock them and tilting the pawl unit back in the direction of the paper exit unit (fig. Open the pressure-release lever on the end of the fuser unit (fig. 2. 15). 3. 6-22 Consumables and Preventative Maintenance Chapter 6 CAUTION: If you are replacing the pressure-release pieces after the printer has been running, make sure the fuser unit has cooled. The fuser gets very hot and can damage these pieces. If you are replacing the two pressure-release pieces (one at each end of the fuser roller), skip to step 5. [. . . ] 1-12, 4-29, 4-58, B-2 PostScript emulation mode . B-3 Power cable See Power Cord Power cord . 2-34, 6-11 Pressure-release pieces Moving the printer. 4-37 Printable region See Imageable region See Margins Printer Access . [. . . ]