User manual KONICA MINOLTA MARINE CASE MC-DG100

[. . . ] Minolta Europe GmbH Reparatur/Repair Minolta France S. A. Minolta (UK) Limited Minolta Austria Ges. Belgium Branch Minolta (Schweiz) AG Minolta Svenska AB Finland Branch Minolta Portugal Limitada Minolta Hong Kong Limited Minolta Singapore (Pte) Ltd. 3-13, 2-Chome, Azuchi-Machi, Chuo-Ku, Osaka 541-8556, Japan 101 Williams Drive, Ramsey, New Jersey 07446, U. S. A. 369 Britannia Road East, Mississauga, Ontario L4Z 2H5, Canada Minoltaring 11, D-30855 Langenhagen, Germany Senator-Helmken-Strasse 1, D-28197 Bremen, Germany 365 Route de Saint-Germain, F-78420 Carrieres-Sur-Seine, France 7 Tanners Drive, Blakelands, Milton Keynes, MK14 5BU, England Amalienstrasse 59-61, A-1131 Wien, Austria Zonnebaan 39, P. O. [. . . ] Dab a small amount of grease between your fingers and draw the ring through your fingers until it is evenly coated. Too much grease attracts foreign matter. · Only use the supplied grease; the use of other types or brands of O-ring grease may damage the O ring and cause leakage. · Do not bend or twist the ring when fitting it into the O-ring channel. It may prevent the ring from forming an adequate seal and cause leakage. O ring may have to be replaced more frequently, depending on maintenance, the amount of use, and storage conditions. · You can purchase additional O rings and grease from your dealer or at a Minolta Service Facility. O-Ring Set (6776-751) includes a ring and a tube of grease. Tripod socket Front glass Care should be taken to keep this surface clean. Left and right buttons Mode switch Zoom buttons Latch OPERATION ENVIRONMENTS · Do not load or open the Marine Case in a wet, sandy, or dusty environment. · Install the camera, memory card, or battery in a cool, dry environment to reduce the formation of condensation. · The camera has been designed for use in temperatures from 0°C to 40°C (32°F to 104°F). When used in the case, do not use the camera continuously for more than 30 minutes in temperatures over 35°C (95°F). · Do not expose the case to large waves or swells. · Moving the case between hot and cold environment may cause condensation (water droplets) to form internally. Condensation may result in damage to the camera. Place the case in a sealed plastic bag to prevent condensation from forming. Allow the case and camera to come to room temperature before removing them from the bag. If condensation forms inside the case, remove the camera immediately, and wipe the condensation from both the camera and case with a soft, dry cloth. Place the camera and case in a dry place for several hours to allow all moisture to evaporate. · Never leave the case exposed to extreme temperatures, such as in a car parked in the sun or a hot sandy beach. The case may be deformed resulting in leakage. · Never leave the camera and case in a humid environment. It may cause damage. Enter button Display button Flash-mode button Menu button · If sunscreen or tanning lotions come in contact with the case, immediately rinse them off with warm water. [. . . ] · Do not to place the desiccant so that it covers the camera flash. · The desiccant should be replaced after every use. · Packets of desiccant weighing 1g to 2g can be used. They can be purchased at a camera store or diving shop. A RECORDING Refer to the camera's instruction manual for detailed instructions. [. . . ]