User manual KONICA MINOLTA MICROPRESS MX PRINT SERVER OPERATOR MANUAL

[. . . ] T+ Server Installation Guide Copyright © 1995­2002 T/R Systems, Inc. All Rights Reserved Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. The information contained in this document is subject to change without notice. T/R Systems makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. [. . . ] · Be sure to unwind the power cord prior to plugging it in. Using it tied up may lead to damage, overheating, short-circuit or result in fire. · Be sure to fully plug the power cord into the power outlet, as any flammable material caught between an opening may result in fire. However, if this is unavoidable, be sure to take the following precautions. Failure to do this may lead to overheating, resulting fire, or cause flickering due to a drop in voltage. Be sure not to exceed the allowed rating current of the extension cord. Do not connect several extension cords together as this is dangerous. Do not attempt to service the equipment by yourself, except as instructed in the manual. Opening or removing those covers that are intended to be removed only by qualified service personnel may expose you to dangerous voltage points or other risks. Refer all servicing in those compartments to qualified service personnel. 2 Warning: · The equipment should never be placed near or over a radiator, heat register, or flame. · This equipment should not be placed in a built-in installation unless proper ventilation is provided. · Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation of the equipment and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the printer on a bed, sofa, shag rug, or other similar surface. · Before connecting the printers to a power source, check the voltage rating label on the rear of the equipment to ensure that the printer voltage matches that of the power source. If a voltage label is missing, contact the nearest authorized dealer or the place of purchase before operating equipment. · If the extension cord is used with the equipment, make sure that the total ampere rating of the products plugged into the extension cord does not exceed the extension cord ampere rating. · The power cord should be routed so that it is not likely to be walked on or pinched by items placed on or against it. Pay particular attention to the plug, the receptacle, and the point where the cord exits the unit. · When connecting cable to or disconnecting cables from the equipment, make sure that the power switch is in the off position. · Keep the power cord and cables away from children. · Do not handle power cords with wet hands. [. . . ] Proper care should be used when handling and installing the cables. The following instructions should be observed to avoid damage to the cables during use. · THIS CABLE IS NOT TO BE ROUTED UNDER A RAISED FLOOR 7 1 2 3 4 1 2 3 4 Never pinch or bend any cables around sharp corners. It should connect without excessive force. [. . . ]