User manual KONICA MINOLTA SC-210

[. . . ] SC-210 User's Manual (D/N: 250-0278-E Rev. 1. 0 ) Minolta-QMS, Inc Trademarks Microsoft is a U. S. registered trademark of Microsoft Corporation. Windows and MS-DOS are trademarks of Microsoft Corporation. [. . . ] Press the "Normal/Quality" button. The Message Window displays "Normal mode". Repress the "Normal/Quality" button and the Message Window displays "Quality mode". The copying begins processing with the Quality mode. See following photo/text reproduction between normal copier versus the Minolta-QMS SC-210 in quality mode. Make copies with a normal copier ã Note: · · Make copies with a SC-210 in quality mode To proceed copies using Quality Mode, make sure your printer has adequate memory as this requires more processing time. Copies made using QualityMode take longer to print than copies made utilizing Normal Mode. 3-11 3. 4. 8 ORIGINAL CONTENT AUTO/TEXT/PHOTO COPIES Content can vary widely. The SC-210 can be configured to maximize the copy operation based upon the content of the original. If the content of the original is a photograph images only or has photograph images with a little text on it, select the Photo function to get a photo-concentrated image copy. The Text function optimizes the copy if the original is mostly text. However, if the proportion of the photo image is almost the same as that of text in the original to be copied, it is recommended to use the Auto function from Auto/Text/Photo button in order to get the most optimal printout with photo and text mixed. Place your document face-down on the document glass. Keep on pressing "Auto/Text/Photo" button to select any one of these 3 document-type functions, called Photo, Text, and Auto. Press the Copy button, and the printout shows the best reproduction with the document-type concentration selected. 3-12 - 3. 4. 9 MAKING COPIES OF A 3D OBJECT The Minolta-QMS SC-210 solution improves your copy reproduction significantly and even makes 3D object copies amazingly clear. Place your 3D object on the document glass. Press the "Normal/Quality" button and the Message Window displays "Normal mode". Repress the "Normal/Quality" and the Message Window displays "Quality mode". Your 3D object copy is done. The 3D copy using a normal copier The 3D copy using the Minolta-QMS SC-210 3-13 3. 4. 10 AUTOMATIC POWER SAVING The SC-210 features automatic power saving without unplugging the power cable. If you have not used the SC-210 over a selected powersaving interval (15 minutes, 2 hours, or 4 hours), it automatically turns into power saving status. To resume the ready status, press any one of the buttons on the Control Panel. The Message Window displays "Warming up. . . " and then "1 Copy @100%", the ready status. The SC-210 can also have the power saving mode disabled entirely. To change the SC-210 power saving mode, press the Menu button and select Sleep. [. . . ] Press the Preview button to get an initial scanned image at a low resolution to allocate your selected scan area. Open the ADF document cover to take out the document and then position it on the first page of the document on the ADF Paper Tray. Finally press the Scan button on the bottom of TWAIN window or the Scan button on the Control Panel. 3. 4. 7. 8. 9-11 The Preview Button The Scan Button 9-12 - 9. 3 MAINTAINING THE ADF 9. 3. 1 CLEANING THE ADF The SC-210 is designed to be maintenance free. [. . . ]