User manual KONICA MINOLTA ZOOM 60

[. . . ] This mark on your camera certifies that this camera meets the requirements of the EU (European Union) concerning interference causing equipment regulations. Using batteries improperly can cause them to leak harmful solutions, overheat, or explode which may damage property or cause personal injury. Do not ignore the following warnings: Only use the batteries specified in this instruction manual. Do not install the batteries with the polarity (+/­) reversed. [. . . ] Be extremely careful to keep sand from both the interior and exterior of the camera and its accessories. ⷠKeep the AF windows clean to ensure accurate focusing. ⷠIf the camera body is dirty, gently wipe it clean with a soft, clean, dry cloth. ⷠTo clean the lens surface, brush away any dust or sand and then gently wipe the lens surface in a circular motion with a clean cloth or tissue for optics. Never touch the lens surface with your fingers. ⷠNever use alcohol or solvents to clean the camera. ⷠStore the camera in a cool, dry, well-ventilated area away from dust and chemicals. For very long periods, place the camera in an airtight container with a silica gel drying agent. ⷠBefore using after prolonged storage, always check the camera's operation to make sure it is functioning properly. ⷠBefore important events or journeys, check camera operation carefully or take test photographs. ⷠMinolta is not responsible for any loss which may occur due to an equipment malfunction. ⷠIf you have questions about your camera, contact your local camera dealer or write to the Minolta distributor in your area. ⷠIf the data panel is blank, turn the camera off and on. If "0" appears alone on the data panel, do not open the back cover. Turn the camera off and remove and reinsert the batteries. Before shipping your camera for repair, please contact an authorized Minolta Service Facility for details. ) Based on Minolta's standard test method: flash used with 50% of the exposures with fresh batteries. Without batteries Specifications are based on the latest information available at the time of printing and are subject to change without notice. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] ⷠFocus lock is canceled when the shutter button is released. The camera's AF system may not be able to focus in certain situations for example, when the subject is behind glass. Use focus lock on an object at the same distance as the subject and then the image can be recomposed to take the picture. When the camera is turned off, the mode is reset to autoflash. [. . . ]