User manual KONICA NT RIP GETTING STARTED GUIDE REV 12

[. . . ] Konica NT RIP Getting Started Guide Additional documentation can be found in the Documentation folder on your Konica RIP CD AG12333P3 Rev. 12 Konica NT RIP Getting Started Konica NT RIP Getting Started Guide This guide reflects the Konica NT RIP Getting Started Guide as of September 2004. © copyright Konica Incorporated 2004 Proprietary Notice The information contained within this guide is the property of ECRM. No transmission, reproduction, transcription, storage in a retrieval system, translation into any language or other use is permitted in whole or in part in any form without first obtaining written permission of ECRM. [. . . ] Set Dot Shape: and select Override Dot Shape in job. Set Frequency and select Override frequency in job. Select Use Harlequin Precision Screening if desired, and make the appropriate settings. Select Use extra gray levels if desired and fill in Limit number of gray levels to: Step 12 Step 13 Step 14 Step 15 Step 16 Step 17 Step 18 Step 19 24 Konica NT RIP Getting Started AG12333P3 Rev. 12 CONFIGURE DEVICE Step 20 Select Rotate screens according to page rotation. Step 21 Click OK. ·The Separations Manager window displays. Step 22 Click OK. ·The New Page Setup window displays. Step 23 Click Configure device. . . if not grayed out. Note: The Device Configuration dialog box for your recorder displays. The Configure Device Section explains each type. C o n figure D evice There are five possible Configure device windows that you will see depending on the type of recorder that you selected in the Output device: entry: one for MAKO HT recorders, one for Cut-to-size recorders, one for non Cut-to-size recorders, one for EV-jetsetter 9200 recorders, and one for DesertCat devices. Some recorders do not require a Configure device window, in which case the Configure device button is grayed out. Follow the directions below for your recorder as identified by the illustration of the window. AG12333P3 Rev. 12 Konica NT RIP Getting Started . . . . . 25 Configuring the RIP MAKO HT RECORDERS Figure 1. Device Configuration Window (Mako HT) Step 1 First, set the Image Spacing units to your desired unit of measure, e. g. Set the image spacing value to the distance between images that you want. The Configure Device operation is complete for this type of recorder. NON CUT-TO-SIZE RECORDERS Step 2 Step 3 Step 4 Figure 2. Device Configuration Window (Non Cut-to-size) Step 1 Step 2 First, set Distance Units to your desired unit of measure. Set Punches to: Both head and tail punches or Head punch only or No punches. Note the explanatory graphic on the left side of the window. Set Head Punch / Distance to the distance you want between the centerline of the head punch and the edge of the image. Step 3 26 Konica NT RIP Getting Started AG12333P3 Rev. 12 CONFIGURE DEVICE Step 4 Step 5 Set Head Punch / Placement to Inside image or Outside image. Set Tail Punch / Placement to Inside image or Outside image or From head punch. Set Tail Punch / Distance to the distance you want between the centerline of the tail punch and the edge of the image or between the centerline of tail punch and the centerline of the head punch. Finally, set Image Spacing to the distance you want between the centerline of the tail punch of one image and the centerline of the head punch of the next. Note the explanatory note on the bottom left of the window. [. . . ] 12 MEDIA MANAGER Me d ia Manager Note: Media Manager is NOT to be used when using a TIFF device for output. Step 1 Leave settings at zero. In most cases, operation of the RIP is most efficient if all settings in the Media Manager are left at zero. If you plan to use Media Manager, see the RIP Operator Guide. Never check the check box labeled Disable media management. [. . . ]