User manual KORG 168RC

[. . . ] These button groups are positioned at each side of the crossfader. . . 1. Simply press the buttons for the corresponding video sources that you want to place on each channel or side of the cross-fader. When an input is selected the button will glow red Note: Note: Note: The same video source can be used for both channels at the same time ­ more about this later. When a video source is selected for an input that is not connected, you will see a blue-screen. [. . . ] When a video source is selected for an input that is not connected, you will see a blue-screen. When an input button is pressed twice it will blink, and you will see a black screen. Selecting a Source to Monitor Located on the top panel of the krossfour is a row of buttons labeled 1, 2, 3, 4, and OUT. When a video monitor is connected to the monitor output (located on the front panel), any of the 4 inputs or the main output can be viewed, allowing you to "cue" up to specific points of a video source. . . 1. Press the button for the corresponding video source that you want to monitor in the monitor select section. When a source is selected the button will glow red. Note: The monitor out can be treated as a 3rd output for the krossfour, if OUT is selected in the monitor select section. Holding or Freezing a Source Located below each of the two input groups for each channel is a HOLD button. This will freeze any incoming source on the specified channel. . . 1. Press the HOLD button on either channel when a source is being viewed through it. The image will freeze and the button will glow red. To release the frozen image press the button again. You will see the image from channel 1 passing through, but only where blue used to be. 3 krossfour EasyStart Using the Luma Key Function The Luma key function allows the krossfour to ignore black, white, or grays in a video source, and allows the second channel to pass through in the black, white or gray areas. . . 1. Select two different input sources for channels 1 and 2 - make sure that channel 2 source has black, white or gray in it. Move the cross-fader to the far-right position. Move the mode switch located on the front panel, to position 4, labeled L-K. Using the fine-tune knob located on the front panel, eliminate or key out black, white, or grays from the channel two source. You will see the image from channel 1 passing through, but only where black, white, or grays used to be. Combining Features and Functions The krossfour contains many unique features and functions. The real magic for a visual performance begins when these features and functions are combined. Assign same video source to both channels Put cross-fade curve to 4th position Set the mode switch to Black (B). Apply HOLD to channel B Move cross-fader back and forth over the cut off point creating a stutter effect. Release HOLD and repeat process (steps d-g) as video advances. [. . . ] Assign same video source to both channels Put cross-fade curve to 4th position Set the mode switch to Black (B). Apply HOLD to channel B Move cross-fader back and forth over the cut off point creating a stutter effect. Release HOLD and repeat process (steps d-g) as video advances. Experiment using different fader curves. 2. [. . . ]