User manual KORG AX100G

[. . . ] P. 2 p. 18 S. 34 P. 50 EFGJ 1 Precautions Location Using the unit in the following locations can result in a malfunction. · In direct sunlight · Locations of extreme temperature or humidity · Excessively dusty or dirty locations · Locations of excessive vibration THE FCC REGULATION WARNING (for U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Otherwise, rotate the Type knob to select TUBE OD. If the Type knob is already located at the TUBE OD position, turn it first to another effect type, and then turn it back to TUBE OD. Editing other effects Press the select switch for the desired effect to be edited. MOD: Edits the Modulation effect (e. g. , chorus) PEDAL: Edits the Pedal effect (e. g. , wah) AMB: CABI: Edits the Ambience effect (e. g. , delay) Edits the Cabinet effect which models the cabinet resonances of a guitar amp NR LEV: Edits the noise reduction and program level (volume) For some effects, the Modulation and Pedal effects, or the Pedal and Ambience effects cannot be used simultaneously. In the case of such a combination of effects, attempting to turn on both simultaneously will automatically turn off the previously-on effect. As an example, here's how to select CHORUS as the Modulation effect. The LED beside it will blink, indicating that the Modulation effect is selected. Even if the Modulation effect has been turned off within the program, it will be turned on at this point. Rotate value knob 1 (TYPE) to select CHORUS. The type name will appear in the multi-display. If you select the effect that had originally been selected, the Original icon will appear in the multi-display. Value knobs 2, 3, 4 and 5 will adjust the chorus speed (SPEED), chorus depth (DEPTH), chorus feedback amount (FEEDBACK), and the mix balance between the chorus sound and the direct sound (MIX). If the adjusted value matches the unedited value (the original parameter value) as you rotate a knob, the Original icon will appear in the multi-display. The value knobs that can be used and the parameters that are assigned will depend on the type of each effect. (See p. 12 "Effect parameters. ") Select Modulation effect type Original icon 10 3. Editing Using the TAP switch to edit the delay time When using the Ambience or Pedal DELAY effect, press the TAP switch two times at the tempo of the song you are playing. The AX100G will detect the interval, and set the delay time automatically. You can set the delay time in the same way even while you are not playing. Modifying the program name Press the NR LEV switch so that the LED beside the switch is blink. Use value knob 2 to select the character that you wish to change (the character will blink), and use value knob 1 to change the character. The available characters are shown below. Available characters If you wish to save the modified program name, you must perform the "Writing programs" operation. If you turn off the power or select a different program without writing the program, the program name you edited will revert to its previous setting. Writing programs Here's how to write an edited program. Press the WRITE switch, and the Multi-display will indicate "WRITE. " The number LED will blink. Use the UP and DOWN switches to select the destination for your program. [. . . ] Recording will begin automatically when you start playing your guitar, and the pedal indicator will change from blinking to lit. Recording will end when you record up to the maximum time, or when you once again advance the pedal all the way. When recording ends, the pedal indicator will go dark, and the recorded sound will be played back as a loop. If you wish to redo the recording, repeat from step "3. [. . . ]