User manual KORG AX10B

[. . . ] · In direct sunlight · Locations of extreme temperature or humidity · Excessively dusty or dirty locations · Locations of excessive vibration Power supply Please connect the designated AC adaptor to an AC outlet of the correct voltage. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. Interference with other electrical devices This product contains a microcomputer. Radios and televisions placed nearby may experience reception interference. Operate this unit at a suitable distance from radios and televisions. Handling To avoid breakage, do not apply excessive force to the switches or controls. Care If the exterior becomes dirty, wipe it with a clean, dry cloth. [. . . ] It is not possible to edit when other functions are assigned to the value knobs, when the AX10B is bypassed, muted, or recording in Phrase Trainer mode. 12 Setting the noise reduction and program levels 1. If you are in Play mode, press the NR-LEVEL switch. By rotating value knobs 1 or 2, or pressing the NRLEVEL switch, you can access the screen displays for adjusting the noise reduction and setting the level for each program. To adjust the amount of noise reduction, use value knob 1 (range OFF. . . 10: shown in the MASTER/ VALUE display). To adjust the level of each program, use value knob 2 (range 0. . . 10: shown in the MASTER/VALUE display). When you finish making settings, press the EXIT switch to return to Play mode. Modifying program names Press the RENAME switch and specify the desired program name. Use the cursor switches ( , ) to select the character that you wish to change (the character will blink). Then use value knob 5 (or the MASTER/VALUE switches) to select the desired character. The available characters are shown below. Available characters Select characters Move between character positions If you wish to save the modified program name, you must perform the "Program write" operation. If you turn off the power or select a different program without writing the program, the program name you edited will revert to its previous setting. Writing programs Here's how to write an edited program. Press the WRITE switch, and the name display will indicate "WRITE. " The bank number display and the program LED will blink. The power-on display will appear, and you will enter Play mode. 3. When it stops, release your hand and press the WRITE key. Press slowly The LCD display will indicate "COMPLT" for approximately one second. Then the power-on display will appear, and you will enter Play mode. After the adjustment procedure has been completed, verify the operation of the pedal. Select an effect that will make it easy to verify the adjustment. For example, set the pedal effect block to the VOLUME effect, set the value to 0, and check the MIN level when the pedal is returned all the way. If you make a mistake during the calibration procedure, the LCD will indicate "ERROR, " and you will return to the screen before the adjustment (the "MIN" display). If the "ERROR" display appears for repeated attempts, a malfunction may have occurred. In this case, please contact your dealer. 14 Troubleshooting If you suspect a malfunction, please check the following points first. If this does not resolve the problem, contact a nearby dealer. Power does not turn on · Is the AC adapter plugged into an AC outlet? [. . . ] Knob 3 TONE Adjust the tonal quality of the echo. Knob 4 ------ -------- Knob 5 MIX Adjust the mix amount of the echo. Reverb This effect model simulates the reverberation of a room or concert hall, or the reverberation produced by a plate or spring reverb device. ROOM "ROOM" This simulates the reverberation of small studio-sized rooms to medium-sized rooms such as a garage. HALL "HALL" This simulates the reverberation of medium-sized halls to large halls. [. . . ]