User manual KORG AX1G

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Unauthorized changes or modification to this system can void the user's authority to operate this equipment. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. [. . . ] The SAMPLE BANK buttons will light green if they contain a loop sample or red if they contain a one-shot sample. When you press a button that contains a one-shot sample, the button will momentarily go dark and the one-shot sample will play. NOTE If a sample effect is selected for the program, playback will begin when you touch the touch pad after selecting a SAMPLE BANK button. If you want to adjust the sample playback volume for all banks, use the level slider. Use the PROGRAM/BPM knob to adjust the start point in steps of 1/32nd of a beat, over a range of ± 1 beat. , located above the button) will display a bar graph, and LEDs above the remaining banks will indicate their respective level points. Loop samples can be sliced into equal parts. You can select whether each sliced part will play or not play. Sliced parts that do not play are skipped, so the overall length of the loop will be made shorter. This allows you to create a variety of new rhythmic figures and loops from the same original data. For example by playing only the first two beats and last two beats of a All eight PROGRAM MEMORY buttons will light (by default). When you are not using an SD card, keep it in the protective case that was included with the card to prevent it from being damaged by static electricity. Do not leave an SD card where it is accessible by infants or children who might place it in their mouth and swallow it. Carefully read and observe the owner's manual included with your SD card. Press the card inward and release it, and the card will pop out. NOTE Before you can use an SD card, you must format it on the AX1G. The card may not work if it was formatted on another device. About the write protect setting of an SD card SD cards have a write protect switch that prevents the data from being overwritten Using SD memory cards When formatting is complete, the display will indicate "End. " Press the TAP/RANGE button (lit orange) to return select another parameter, press the SHIFT button to return to normal operation. NOTE The entire contents of the card will be lost when you format it. Press the TAP/RANGE button (lit orange) to return select another parameter, press the SHIFT button to return to normal operation. NOTE Don't use your computer or digital camera to format (initialize) a card you plan to use with the AX1G. [. . . ] When you've installed all of the software you selected, exit the installer. In order to use Sample Librarian/MIDI Editor via a USB connection, you must install the "KORG USB-MIDI driver" in your computer. Before you proceed, finish installing KORG USB-MIDI Driver Tools into your computer. NOTE The driver must be installed separately for each USB port. [. . . ]