User manual KORG AX3000G

[. . . ] For connection to a guitar amplifier, press the AMP/LINE button, then use the / buttons or rotate VALUE KNOB 1 to choose from three different types of guitar amps selections: AP1: Choose this setting if you're connected to a clean-sounding amp such as an open-backed US-manufactured combo amp. AP2: Choose this setting if you're connected to an amp with a distinctive sounding Mid-range such as a UKmanufactured open-back combo Amp. AP3: Choose this setting if you're connected to a stack with a closed-back 4 x12 cabinet(s). Tuning When you power-on the AX3000G and make the connection settings above, you'll be in "Program Select" mode. [. . . ] The name display indicates "*WRITE*", and the BANK display and PROGRAM LED's 1­4 will flash. Use VALUE KNOB 1, the / buttons, or the BANK UP/DOWN switches to select the bank you want to use; then use the </> buttons, or PROGRAM SELECT switches to select the destination program 1­4. The program will be saved, the name display will indicate "COMPLETE, " and you'll return to Program Select mode. ! The newly-saved program writes over the previous contents of that bank/program. If you decide not to store your new program, press the EXIT button to cancel the procedure. Note that if you switch to a different program or turn off the power without storing the Program you edited, your changes will be lost. Individual Mode In this mode, you can individually turn each effect type on or off just as if you were using a collection of stomp boxes. You can select INDIVIDUAL mode from any program. To enter INDIVIDUAL mode from PROGRAM SELECT mode, press and hold the BANK UP switch for about one second; the LED above the BANK UP switch will light green. Here's how to switch the pre-effect and reverb on or off while you're playing: 2. Press the "program select" switch 1 to turn the pre-effect on/off. The LED 1 lit/ dark state indicates the on/off status of the pre-effect. Press the BANK DOWN switch to turn the reverb on/off. The LED at the upper left of the BANK DOWN switch will be lit or dark to indicate the reverb's on/off state. To exit INDIVIDUAL mode, press the BANK UP switch, and the green LED will go dark (not lit). Expression Target Quick Assign Here you can easily assign many effect parameters of the AX3000G to its expression pedal for real time live control!For example, you can assign the speed of a modulation effect, time of a delay, or mix of the reverb to the expression pedal. And of course, the expression pedal can also act as a volume pedal or wah pedal effect. As an example, let's assign the Pitch parameter of the PITCH SHIFTER to the expression pedal: 1. Use the Modulation MODEL SELECTOR to choose the PITCH SHIFTER. [. . . ] Time=7. 7, Lo Damp 3. 7, High Damp 5. 4, Pre Delay 0, Mix 4. 5 The Control Switch You can assign the control switch to function in a variety of ways. It can act as an on/off for your effects/amp/cab models; a tap tempo for modulation or delay, or even as a trigger for the ESS. Below is a list of the Control Switch functions. [. . . ]