User manual KORG CX3

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. [. . . ] You can also adjust settings such as the amount of effect that will be applied. For details on these settings, refer to “Editing the settings” (See page 14). Note: Immediately after the power is turned on, the effect will be off. 'a' and 'b' will remember the settings that you had last specified before turning the power off. Note: You can also exit Edit mode by pressing the , , or + buttons as well as the CLIP/PAD button. By holding down the + button, you can step through the rhythm patterns. The pattern number in the display will blink while the rhythm pattern is switching. Once the change has occurred, the display will revert to indicating the sound number. For details on each rhythm pattern, refer to “Rhythm Patterns” (See page 69). Note: You can adjust the volume of the rhythm pattern. refer to “Editing the settings” (See page 14). Immediately after the power is turned on, the original rhythm pattern 00 will be selected. During playback and recording, the pad sensitivity will automatically be lowered to prevent acoustic feedback. You can mute (or unmute) the sound of the rhythm pattern if desired. If you mute the rhythm pattern, you'll hear only the performance that you overdubbed. Hold down the SHIFT button and press the FX button. Each time you do so, muting will turn on/ 12 Performing off. When muted, the rhythm pattern / looper select indicator will blink. Note: If you select another rhythm pattern (or switch to the Looper) while muted, muting will automatically be cancelled. When you've finished performing, press the or button. If you press the button, recording will end and playback will continue. If you press the button, recording will end and playback will stop. [. . . ] € No sound will be output from the speaker if a cable is connected to the headphone jack or the OUTPUT jack. Error messages The WAVEDRUM Mini automatically performs an internal check when its power is turned on. Initialize the data as described in “Restoring the factory settings” above. Immediately stop using the WAVEDRUM Mini, and contact your nearby Korg dealer. [. . . ]