User manual KORG D1600

[. . . ] You can select two different types of meter view, Pre-Fader (before the fader) and Post-Fader (after the fader), and three types of track views, which enable you to see which tracks contain recorded audio. To change the display mode, press the " " button at the top left-hand side of the display. INSERT EFFECT ­ In this mode you can set insert effect assignments on input or on track playback, and assign the effect type. By pressing one of the Insert effect tabs (InsEff1, etc. ) you can select an Insert effect. [. . . ] Press the [METER/ TRACK VIEW] key, then press the " " popup button in the upper left of the display Select "PreFdr" from the list and press "OK" Now you can play your audio sources and adjust the levels so that they do not clip ("CLP" line in display). To enable recording on those tracks, press the orange keys one more time to change them to red, and press [ the D1600 in record standby mode. To start recording, press [ Listening to the recorded tracks: 11. To return to the beginning of the song, press and hold [ ] and then press [ ] once. 12. Press to set each of the track status keys to green for each track you want to listen to, by pressing them twice. Press [ ] and set your levels with the track faders and master fader. Working with EQ on playback: 1. Using the four way CURSOR keys [ ] and the DIAL, select the "knob" in the display for the EQ parameter that you would like to adjust for a specific track. The upper left hand side of the display will show the parameter and track you will be working with. (To change EQ settings for tracks 5-8, 9-12 and 13-16 press the tabs on the bottom of the display) 3 D1600 EasyStart Using the Insert Effects: 1. 2. Press the [INSERT EFFECT] key, and then press the " " popup button in the display to the right of "Assign". To assign an insert effect to a recorded track, select "PlayTrack" by pressing the "radio button" to the left of "PlayTrack", and then press "OK". (Note: To assign an insert effect to an audio source before recording it to a track, select "Input" by pressing the radio button to the left of "Input" and then press "OK") To select the type of insert effect(s) you will be using, press the " " popup button to the left of "1 in 1 outx4", and then press "OK". (For more information on insert effect types refer to the Owners Manual pg. To select the track where the insert effect is going to be applied, press the " " popup button in the display below "InsertTo:". Using the CURSOR keys and the DIAL, select the assign channel and destination, and then press "OK". To select an insert effect, press the "insert effect" tab for the effect that you want to change (ex. "InsEff1" for Insert Effect 1) and use the DIAL to select and effect. To edit a selected effect's parameters, press the "effect name" button in the display (ex. MM2:P4EQ-Wah ) and then press the "icon" in the display to access the edit parameters. 3. [. . . ] Once you've set locate points, you can edit the specific region in the track(s). To see the list of edit functions, press the " " button next to "CopyTrack" in the display. To select a function, press the "radio button" to the left of the function you wish to perform and then press "OK". For more information on editing tracks, refer to the Owner's Manual pgs. [. . . ]