User manual KORG DT1 PRO

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. [. . . ] €¢ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. €¢ Consult the dealer or an experienced radio/TV technician for help. Unauthorized changes or modification to this system can void the user’s authority to operate this equipment. Notice regarding disposal (EU only) If this symbol is shown on the product, manual, battery, or package, you must dispose of it in the correct manner to avoid harm to human health or damage to the environment. Contact your local administrative body for details on the correct disposal method. If the battery contains heavy metals in excess of the regulated amount, a chemical symbol is displayed below the symbol on the battery or battery package. Tilt slit: The slit located on the back of the GA-1 is used to tilt the tuner. Place a guitar pick or similar object in the slit. IMPORTANT NOTICE TO CONSUMERS This product has been manufactured according to strict specifications and voltage requirements that are applicable in the country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. For example if you want to tune each string of your instrument using a reference pitch of A=436 Hz, adjust the tuning of each string so that the needle indicates two steps below «440». While tuning with the onboard mic a quiet environment is recommended for precise tuning. –  Sound mode In this mode you can tune while listening to a reference pitch. Press the [SOUND] switch to enter Sound mode. Press the [SOUND] switch until the note to which you wish to tune appears in the display. For the notes that can be output, refer to step 3 of «Meter mode. » When you make a complete cycle, you will return to Meter mode. - GUITAR will output a pitch that is one octave higher than the actual pitch of your instrument, and BASS will output a pitch that is two octaves higher. Listen to the pitch sounded by the GA-1, and tune your instrument accordingly. — Flat tuning You can use Meter mode or Sound mode to tune to a pitch that is lowered by ) for the specified note. [. . . ] — Flat tuning You can use Meter mode or Sound mode to tune to a pitch that is lowered by ) for the specified note. 1–5 semitones ( – 1. As described in "Meter mode" or "Sound mode, " make the note you wish to flatten by 1–5 semitones appear in the display. Press the [FLAT] switch to select the number of semitones that you wish to lower the selected note. [. . . ]