User manual KORG DT7

[. . . ] Bedienungsanleitung Herzlichen Dank für den Kauf des KORG GUITAR/BASS CHROMATIC TUNER DT-7 Using Buzz Feiten tuning Use this mode only if you have a guitar that is designed with the Buzz Feiten Tuning System. The Buzz Feiten Tuning System (BFTS ) adds slight adjustments to the pitch (similarly to "stretched tuning" on a piano) to make your playing sound its best from low through high ranges, regardless of chords or keys. When using Buzz Feiten tuning, tune to the string attack, not the decay. [. . . ] Press switch 2 ( ) to select OPEN (open string tuning), and tune your instrument so that the center LED lights. If the batteries run down during use, the note name LED display will be interrupted by a message of "b, " "a, " "t, " "t. " The unit can still be used for a time, but accurate tuning will not be possible. You should install a new battery as soon as possible. Slide the lid of the battery compartment (located on the bottom of the DT-7) in the direction of the arrow, and lift the lid up to open the compartment. Install the new battery, making sure that the polarity is correct. Power supply Please connect the designated AC adaptor to an AC outlet of the correct voltage. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. Operate this unit at a suitable distance from radios and televisions. Reset In the following cases, the DT-7 will be reset to the default settings (calibration: A=440 Hz, Reference tone: A4) • When you turn off the power switch. € If the battery runs down • If the battery is removed while the AC adapter is not connected • If the AC adapter is unplugged while still connected to the DT-7 Changing the calibration setting 1. At this time, the note name LED will indicate the last digit (8. 5, F) of the calibration value in the range of 438 Hz. When the note name LED indicates "F, " the tuner is in flat tuning mode. Handling To avoid breakage, do not apply excessive force to the switches or controls. Panel and functions Mute switch jack Function select switch Power switch BFTS CHROMATIC Care If the exterior becomes dirty, wipe it with a clean, dry cloth. [. . . ] And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/ 336/EEC), CE mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC). Also, CE mark which is attached to our company’s products of Battery operated apparatus means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). Playing a reference tone C2--B5 from jack 5 (BYPASS/SOUND OUT) 1. [. . . ]