User manual KORG I2-I3

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] (2) If you are using headphones, use the Phones Volume knob to adjust the level. (1) Control the sound by rubbing your finger across the touch pad or tapping it. (2) If you turn on the Hold key while operating the touch pad, the I2-I3 will hold the effect sound as it was the moment before you took your finger away from the pad. If you move the Pad Motion/Mute lever to MUTE (toward yourself), the input signal, sample sound, or synth/drum sound will be silenced. When using delay or reverb, this lets you output only the effect sound (i. By using the Pad Motion/Mute lever to rapidly switch MUTE on/off, you can create rhythms using a sustained input sound. This is a DJ technique known as "transformer. The I2-I3 lets you record your touch pad operations, and move the the Pad Motion/ Mute lever to the PAD MOTION position to play back these operations. BPM (Beats Per Minute) is the tempo of the song expressed as the number of beats (quarter notes) that occur in one minute. A higher BPM value means a faster tempo. Recording will begin when you hold the the Pad Motion/Mute lever in the PAD MOTION position and touch the touch pad. If you have selected a program from other than the "SAMPLE/PLAY" group, pressing the Sample 1, 2 keys will play back the phrase that was recorded in that key. You can record for approximately six seconds in each of the two keys. The recorded phrases will be lost when the power is turned off. It is not possible to save the recorded phrases. The current state of the KAOSS PAD can be stored in one of the Program Memory 1­8 keys, so that it can be instantly recalled whenever you want. -- Effect program -- On/off state of the Hold key and the held position (coordinates) -- FX/Depth knob setting -- For the "BPM FX/PTN" group, the specified BPM value -- For the "SAMPLE/PLAY" group, the Sample 1, 2 key used Effect programs 60 and 90­99 do not store the state of the Hold key. (1) Press the Rec/Stop key, and the Rec/ Stop key LED will blink to indicate that you are in record-ready mode. (2) Press the Sample 1, 2 key into which you want to record. At this time, you will not hear the playback sound. (3) When you press the Rec/Stop key, the Rec/Stop key LED will light, and recording will begin. Recording will stop when you press the Rec/Stop key once again. [. . . ] When the FX Depth knob is positioned in the center, the playback sound and the input sound will be output in a 1:1 proportion. When the knob is at the maximum position, only the sample sound will be output during playback, and you will not hear the input sound. Connect these cables between the MIDI connectors of the I2-I3 and the MIDI connectors of the external MIDI device with which you want to transfer data. In addition to using the I2-I3 as an effect processor, you can transmit MIDI messages from the I2-I3 to use it as a realtime controller for a synthesizer or other external MIDI device. [. . . ]