User manual KORG I5M

[. . . ] Do not connect it to an AC outlet of voltage other than that for which your unit is intended. CE mark which is attached to our company's products of AC mains operated apparatus until December 31, 1996 means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/ 68/EEC). And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/336/ EEC), CE mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC). Also, CE mark which is attached to our company's products of Battery operated apparatus means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). [. . . ] Making connections and turning on the power Be sure all your equipment is turned off BEFORE you begin hooking everything up. You must excercise caution, otherwise you may damage your speaker system or cause other malfunctions. Connections using USB 1 Use a USB cable to connect the K-Series to the USB connector of your computer. 2 If you want to use a pedal, connect it to the PEDAL jack. The K-Series will detect the polarity of the pedal when the power is turned on. Therefore, if a pedal is connected, do not hold it down while you turn the power on. To turn on the power, set the K-Series' power switch to the USB position. When you are ready to turn off the power, set the power switch to STANDBY. If you're using a USB connection, you generally don't need to use an AC adapter. However if your computer is low-powered, or if you are using a hub that is only buspowered (rather than self-powered), sufficient power may not be supplied to the KSeries. In this case, use the optional AC adapter and set the power switch to the DC position. MIDI messages are sent using MIDI channel. Note messages are sent from the keyboard. Three velocity curves (and a constant 127 velocity) allow the keyboard response to be tailored to the performer's playing style. The keyboard may be transposed by semitones into any musical key. MIDI control changes can be assigned individually to the "X" direction (left/right) and the "Y" direction (up/down) to simultaneously control two parameters. In addition, the ClickPoint can be used as a computer mouse. 127] Moving the ClickPoint controller will change the value of the parameters assigned to the X and Y axis The ClickPoint controller will return to the center position when it's released. To lock the X and Y parameters at their current values, press down (Z axis) on the center switch of the ClickPoint. The Mouse Mode is only operative when the connected to a computer via USB. By assigning MIDI control changes, these knobs can be used to operate external MIDI equipment and control musical software applications. These two switches can be assigned individually to send a specific value to a specific MIDI control change parameter. [. . . ] Hold down [BANK] button until the K-Series enters the Setting mode. You can prevent the internal sound engine from receiving volume change messages. If the Volume message filter is set to "On", the I5M's internal sound generator will accept volume(07) message from Knob1, Knob2 and the Slider if they are assigned control change cc#07. If it's set to "Off", the I5M's internal sound generator will reject volume(07) message from Knob1, Knob2 and the Slider even if they are assigned control change cc#07. [. . . ]