User manual KORG KF4

[. . . ] OWNER’S MANUAL MANUEL D’UTILISATION BEDIENUNGSANLEITUNG Precautions Location Using the unit in the following locations can result in a malfunction. € In direct sunlight • Locations of extreme temperature or humidity • Excessively dusty or dirty locations • Locations of excessive vibration • Close to magnetic fields Power supply Please connect the designated AC adapter to an AC outlet of the correct voltage. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. Interference with other electrical devices Radios and televisions placed nearby may experience reception interference. [. . . ] The switching of input and monitor sources is not image synchronized. This type of switching may cause disturbances in the image. 3 Owner’s Manual Switches and Connectors Top Panel 6 5 1 2 3 4 1. INPUT A SELECT keys These keys select the input source for Channel A. When you press a key, it will light up solid to indicate that the source is selected. If the MODE switch is set to C-K (Chroma-key) or L-K (Luma-key), the selected source will be used as the background image for a compositing effect. Press the same key a second time and it will begin blinking. When the key is blinking, the input source will be ignored, and the output of the channel will depend on the MODE setting. If the MODE switch is set to BK (Black) or WH (White), the blinking key indicates that the unit is ignoring the source image and outputting the specified background color instead. These solid backgrounds can then be used as a source for video mixing. If the MODE switch is set to C-K (Chroma-key) or L-K (Luma-key), the blinking key indicates that the input source will be ignored and a black background will be used for the compositing effect. Note: If there is no device connected to the selected input (or there is no signal from the connected unit), the krossfour will output a blue background screen. INPUT B SELECT keys These keys select the input source for Channel B. When you press a key, it will light up solid to indicate that the source is selected. If the MODE switch is set to C-K (Chroma-key) or L-K (Luma-key), the selected source will be used as the foreground image for a compositing effect. Press the same key a second time and it will begin blinking. When the key is blinking, the input source will be ignored, and the output of the channel will depend on the MODE setting. If the MODE switch is set to BK (Black) or WH (White), the blinking key indicates that the unit is ignoring the source image and outputting the specified background color instead. These solid backgrounds can then be used as a source for video mixing. If the MODE switch is set to C-K (Chroma-key) or L-K (Luma-key), the blinking key indicates that the input selected for Channel B will be ignored and only Channel A will be output. In the C-K Mode, however, if the HOLD key is pressed while any INPUT B SELECT key is blinking, a black screen will be output for Channel B instead. Note: If there is no device connected to the selected input (or there is no signal from the connected unit), the krossfour will output a blue background screen. [. . . ] Output the selected background color from either channel. Either channel can be set to output a black screen image or a white screen image. Choose which Channel will output the background color, and press the currently lit INPUT SELECT key for that channel. The key will start to blink, and the input signal will be replaced by the background color selected by the MODE switch, either black (if the MODE switch is set to BK) or white (if WH). [. . . ]