User manual KORG KM402

[. . . ] Mains powered apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. [. . . ] Please refer to the appendix for directions on how to change the crossfader settings. Power inlet Connect the included power cable to this connector. BOOTH OUT jacks These output the same audio signal as the MASTER OUT jacks. However, their volume is not affected by the MASTER LEVEL knob. INPUT (LINE) jacks You can connect line level equipment to these jacks. MIC jack You can connect a mic to this jack. INPUT (PHONO) jacks You can connect turntables to these jacks. GND terminal This is a grounding terminal for connecting your turntables. If you use the PHONO jacks, you must connect the ground wire(s) of your turntable(s) to this GND terminal. Getting ready Before you connect your equipment, you must turn off the power switches and disconnect the power cables from the outlet. Connections Use the jacks that are appropriate for the equipment you’re connecting. KM-402 PA Mixer TURNTABLE CD PLAYER KM-202 PA Mixer TURNTABLE CD PLAYER 7 Turning the power on When powering-on this Mixer, you must observe the following procedure. Connect the included power cable to the power inlet. Power-on the external devices connected to the mixer’s input jacks. Turn down all of the Mixer’s channel faders and the MASTER VOLUME knob. Turn on the power switch located on the rear panel of the mixer. Power-on the equipment connected to the MASTER OUT jacks, such as your monitor amp. Turn down all of the Mixer’s channel faders and the MASTER VOLUME knob. Turn off the power of your monitor amp or other equipment connected to the MASTER OUT jacks. Turn off the power switch located on the rear panel of the Mixer. Using the mixer Basic operation Selecting the inputs Use the top panel INPUT SELECT switch to select the desired inputs. Adjusting the input levels Use the TRIM knobs to adjust the input level of each mixer channel. [. . . ] The Left setting determines where on the crossfader’s travel Channel B (KM-402) or PGM 2 (KM-202) will completely cease to sound. Likewise, the Right setting determines where on the crossfader's travel CH A (KM-402) or PGM A (KM-202) will cease to sound. Perform this adjustment if the sound does not transition correctly at the edge of the fader, or if you want to shorten the fader stroke. Remember, the X-fader curve knob on the front panel will affect how you perceive these settings. [. . . ]