User manual KORG KP3

[. . . ] Using the unit in the following locations can result in a malfunction. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] You can connect the KP3 to your computer and read/write the contents of the inserted card via USB. This lets you use the KP3 as a MIDI controller. The effects will not function in this mode. The KP3 will transmit the MIDI messages you assigned to each controller using the included PC editor. For the touch pad, you You can use an SD card to save or load data to and from the KP3's internal memory. You can also load samples (WAV files or AIFF files) created on a computer into the KP3 by using a card. NOTE Before you can use the SD card, you must format it on the KP3. Don't use your computer or digital camera to format (initialize) a card you plan to use with the KP3. If the card was formatted on a different device, it may not work correctly with the KP3. NOTE The KP3 must be turned off before you insert or remove the card. NOTE The KP3 supports SD cards with a power supply voltage of 2. If you set the card's switch to the protected setting, it will be impossible to write or erase data on the card, or to format it. If you need to save edited data on the card, move the switch back to its original unprotected setting. Insert the card, making sure that it is oriented correctly. The gold contacts should be facing down, and the angled corner to your right. The SD card may be hot immediately following use. Power-off the KP3 and wait for the card to cool before removing it. Do not bend them, drop them, or subject them to physical shock. Avoid using or storing SD cards in locations of extremely high or low temperature such as in direct sunlight, a closed automobile, or near a heater, or in locations of high humidity or excessive dust. Avoid using or storing SD cards in locations where they may be subject to strong static electricity or electrical noise. Do not allow dirt or foreign matter to adhere to the contacts of an SD card. If the contacts should become soiled, gently wipe them off using a dry cloth. [. . . ] If you want to connect the KP3 to a USB port that's different than the one you used when installing the KORG USB-MIDI driver, you'll have to reinstall the KORG USB-MIDI driver again for that port. When you've finished installing the KORG USB-MIDI driver, exit the installer. If you are asked whether you want to restart your computer now, choose [Yes] to restart the computer. for details on installing , setting-up , or uninstalling the KORG USB-MIDI driver , refer to the installation manual (HTML). [. . . ]