User manual KORG MINI KP

[. . . ] If the exterior becomes dirty, wipe it with a clean, dry cloth. After reading this manual, please keep it for later reference. CE mark which is attached to our company's products of AC mains operated apparatus until December 31, 1996 means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). [. . . ] please replace the batteries as soon as possible. You must turn off the power switch before replacing the batteries. The included batteries are provided so that you can verify that the unit operates correctly, and may have a shorter lifespan than expected. If the batteries become unusable, remove them immediately. You should also remove the batteries if you won't be using the unit for an extended time. On the bottom panel, slide the battery case cover in the direction of the arrow to open it. Make sure that the batteries are inserted in the correct polarity (+, -). Choose the "dir" setting if you are connecting an instrument or audio device directly to the miniKP (as in the diagram above). Choose the "snd" setting if the mini-KP will be connected to the effect send and return jacks of your mixer or other device. To return to the normal play mode, once again hold down the MEMORY A button and press the B button. The mini-KP will also return to the normal play mode (program selection state) after about three seconds if no additional setting operations are performed. This setting will be remembered even when the power is turned off. About the input level The PEAK indicator will light red if the input signal level is too high. In this case, reduce the output volume of the device that's connected to the mini-KP. [. . . ] Hold down the TAP button and the MEMORY A button as you turn on the power; all settings will return to their factory-set state. LINE IN jacks (RCA phono jacks) LINE OUT jacks (RCA phono jacks) HEADPHONES jack (Stereo 1/ 8" mini phone jack) Power supply: four alkaline AA (LR6) batteries (6 V) Battery life: approximately five hours (with alkaline batteries) Dimensions: 106 mm (W) x 129 mm (D) x 29 mm (H) / 4. Hold down the MEMORY A button and press the TAP button, and then use the PROG/VALUE knob to set the effect depth. [. . . ]