User manual KORG MINIKP

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. [. . . ] € This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. C1 Music stand Pupitre Notenständer Atril musical IMPORTANT NOTICE TO CONSUMERS This product has been manufactured according to strict specifications and voltage requirements that are applicable in the country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. WARNING: Use of this product in any country other than that for which it is intended could be dangerous and could invalidate the manufacturer's or distributor's warranty. Please also retain your receipt as proof of purchase otherwise your product may be disqualified from the manufacturer's or distributor's warranty. Parts of the AW-2 and what they do Reference pitch indicator Pure major third, Pure minor third Input indicator High(+) indicator Internal mic Note name indicator Light button Battery cover Tuning procedure 1. The power will turn on/off each time you press this button. If the power is left on for approximately 20 minutes without any sound being input, it will turn off automatically. If necessary, press the illumination button to set the backlight. (* ) Each time you press the illumination button, the setting will cycle between soft → auto → unlit → soft . For example if you want to tune to a pure major third (-13. 7 cents) above A (0 cents), make the note name indicator read C , and tune so that the meter indicates the left [ ]. Alternatively, if you want to tune to a pure minor third (+15. 6 cents) above A (0 cents), make the note name indicator read C, and tune so that the meter indicates the right [ ]. Avoid letting the mic pick up any extraneous sound while tuning. Even if the pitch is within the range of detection, it may not be possible to detect the pitch of an instrumental sound that contains large numbers of overtones or that has a rapid decay (e. , very low or very high notes on a piano). *2 Instead of attaching the AW-2 to the instrument, place the AW-2 in a location for convenient viewing and use the internal mic. *3 Press the input select button to switch to the internal mic (MIC). Meter surface Attach About the included clips The AW-2 and the clip damage may occur if you apply excessive force to any other movable portion or joint, or attempt to move it beyond its intended range of motion. No Small Clip Guitar Clip Reverse the meter display (Reverse function)*M When turning the power on, hold down the power button for one second or longer (the backlight will blink twice). [. . . ] Refer to the table on the other side of this sheet and to the illustrations at the right, and attach the tuner in the recommended location. Depending on the conditions of use, you may also be able to tune with the tuner attached in a different location. You can also switch the input to the internal mic (MIC) and attach the tuner to a music stand rather than to your instrument. If you've selected the internal mic, you can also use the tuner without the clip. [. . . ]