User manual KORG MR-1

[. . . ] E2 Precautions Location Using the unit in the following locations can result in a malfunction. · In direct sunlight · Locations of extreme temperature or humidity · Excessively dusty or dirty locations · Locations of excessive vibration · Close to magnetic fields THE FCC REGULATION WARNING (for U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The selection icon will change from " " to " ". LED setting Normally, the recording LED will light while recording, but you can reduce the power consumption even further by turning this LED function off. Press the menu button, and in the menu list (MENU) screen, use the P-dial to select and confirm "SYSTEM. " The system setting (SYSTEM) screen will appear. Use the P-dial to select "LED. " The selection icon will change from " " to " ", and the setting will be highlighted. Turn the P-dial to select "OFF. " To turn the LED back on again, perform the same operation to select "ON. " Push Push Push 4. Press the P-dial (or the menu button) to complete the LED setting. The selection icon will change from " " to " ". 27 Setting the date and time If you set the MR-1's date and time, the recorded files will have the correct date and time stamp. Here's how to set the internal clock. Press the menu button, and in the menu list (MENU) screen, use the P-dial to select and confirm "SYSTEM. " The system setting (SYSTEM) screen will appear. Use the P-dial to select and confirm the date and time indication in the top line. The date and time setting (Clock) screen will appear. Push Push Push 3. Use the P-dial to select and confirm "Year. " The selection icon will change from " " to " ", and the year indication will be highlighted. Turn the P-dial to select the year, and press the P-dial (or the menu button) to confirm. The selection icon will change from " " to " ". Push Push 5. In the same way, use the P-dial to select and confirm the "Month, " "Day, " "Hour, " "Minute, " and "Sec. " 6. When you've finished making settings, press the menu button to return to the system setting (SYSTEM) screen. Alternatively, you can return by using the P-dial to select and confirm "<-Back" in the screen. If you leave the MR-1 sitting for two or three days and the rechargeable battery does not have enough power to turn on the MR-1, the date and time setting will be reset. After recharging, you'll need to make this setting again. If the date and time have been reset, a message will remind you to make the setting. The time will continue to advance while you're setting it. 28 Protecting a project Here's how to protect a project. If you edit the name or delete or edit the mark settings of a project that is protected, these settings will revert to their original state when you select another project or turn off the power. A protected project is indicated by a lock icon displayed in the project/file information field (the top line) of the level meter screen. [. . . ] Check the file formats that are supported. Please enter name. · There is no project name (the name consists only of spaces). Please enter a valid project name (one or more alphabetical character, numeral, or symbol). Protected Project. · The operation cannot be executed because the project is protected. Turn off the project protect setting. 50 Project Name Error. Delete illegal folder. · An identically named project/file already exists. [. . . ]