User manual KORG MS2000B

[. . . ] While holding down both Program UP and DOWN Switches and the CANCEL Button, connect the power adaptor (or if using batteries, power up by plugging a cable into the input jack). The Program/Value Display will indicate “rL” and the Program Switch LEDs will blink. Press the WRITE Button once (“Ld” will display). The factory programs will be loaded into the user area (01~40). [. . . ] The factory programs will be loaded into the user area (01~40). When loading is completed, the Program/Value Display will indicate “CP” briefly, and program number 01 will be recalled. Note: To cancel this operation when the program value display reads “rL” press the Cancel button instead of the Write button. Note: Note: If you reload the preset programs, all previously stored custom programs will be overwritten!Never turn off the power while this operation is in progress! Selecting and listening to the AX5’s Programs The AX5 pedals provide 80 program locations; 8 banks with 10 programs in each (8x10=80). Programs 01 - 40 are User locations that can be customized and saved. Programs 41 - 80 are factory preset, and can be modified but cannot be overwritten. 1. Tip: Set the Function Selector knob to “PROGRAM”. Using the program UP and DOWN Switches, you can now scroll through and audition all 80 programs. To jump from bank to bank (as opposed to scrolling through each individual program), use the Cancel and Write buttons. Tweak the AX5’s Programs Each of the AX5’s 80 programs can be modified to your liking. A User program number will blink in the Program/Value Display. Use the Program Up and Down Switches or Value Knob to select the destination program number (1 - 40) Press the WRITE (“UP”) Button once again, and your program will be stored in the specified location (“CP” will display briefly indicating the process is complete). Amp/Line Setting (AX5G only) The AX5G’s output may be optimized to suit specific monitoring sources via the Amp/Line setting. Amp/Line settings can be made under the P5 parameter of the Drive/Amp (Note; the amp line setting is only applicable to Amp models {i. e. A0, A1, A2, A3, etc. } and will not be found on Drive models {i. e. Select “A1” if you connect the AX5’s output to the input of a clean-sounding open back combo. Select “A2” if you connect the AX5’s output to the input of an open back combo with stronger mid-range content. Select “A3” if you connect the AX5’s output into a sealed back cabinet such as an amp stack. Select “Ln” if you connect the AX5’s output into a line input such as a mixer, recorder, headphones or any other full range monitoring source. 3 AX5-Series EasyStart Quick Assign - Assigning a specific effect parameter to the Expression Pedal The AX5’s expression pedal can be set to control volume, wah, and many effects parameter like the speed of the tremolo or depth of a reverb. Assigning an effect parameter to the expression pedal using the quick assign feature is easy: 1. First choose an effect type by turning the Function Selector to the appropriate effect section. [. . . ] Select “Ln” if you connect the AX5’s output into a line input such as a mixer, recorder, headphones or any other full range monitoring source. 3 AX5-Series EasyStart Quick Assign - Assigning a specific effect parameter to the Expression Pedal The AX5’s expression pedal can be set to control volume, wah, and many effects parameter like the speed of the tremolo or depth of a reverb. Assigning an effect parameter to the expression pedal using the quick assign feature is easy: 1. First choose an effect type by turning the Function Selector to the appropriate effect section. Use the Write (“UP”) & Cancel (“DOWN”) Buttons to select an effect. [. . . ]