User manual KORG MS2000BR

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. € Increase the separation between the equipment and receiver. [. . . ] € Consult the dealer or an experienced radio/TV technician for help. Unauthorized changes or modification to this system can void the user’s authority to operate this equipment. Thank you for purchasing the Korg BA-40 bluegrass tuner. To help you get the most out of your new instrument, please read this manual carefully. Notice regarding disposal (for EU) If this “crossed-out trash can” symbol is shown on the product or in the operating manual, you must dispose of the product in an appropriate way. Do not dispose of this product along with your household trash. By disposing of this product correctly, you can avoid environmental harm or health risk. The correct method of disposal will depend on your locality, so please contact the appropriate local authorities for details. IMPORTANT NOTICE TO CONSUMERS This product has been manufactured according to strict specifications and voltage requirements that are applicable in the country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. WARNING: Use of this product in any country other than that for which it is intended could be dangerous and could invalidate the manufacturer’s or distributor’s warranty. Tune your instrument to match the reference tone. Sharp/Flat tuning You can use Meter mode or Sound Out mode to tune your instrument to a pitch that's higher or lower than the selected note name. You can't use Sharp/Flat tuning when FIDDLE is selected. This setting is cancelled when you turn off the power or use the [INST] switch to change settings. Meter mode This mode lets you tune while watching the meter in the display. / ] switch several times to specify the desired pitch of your instrument as the number of semitones above or below the selected note name. ) One semitone higher ( ) – Five semitones higher ( One semitone lower ( ) – Five semitones lower ( ) 1. The method will depend on the instrument you're using. When tuning an acoustic instrument If you want to use the optional Korg CM-100L contact mic, connect the plug of the CM-100L to the BA-40's INPUT jack. If you want to use the internal mic, don't connect anything to the input jack. When tuning an electric instrument Use an instrument a cable with mono plugs to connect your instrument to the BA-40's INPUT jack. [. . . ] If you connect a cable to the INPUT jack, you won't be able to use the internal mic. You can connect the BA-40's OUTPUT jack to your amp or other device. In this case, you should first connect your instrument to the BA-40's INPUT jack, and then use an instrument cable with mono plugs to connect the OUTPUT jack to your amp. The sound of your instrument will be sent from the BA-40's OUTPUT jack to your amp, allowing you to tune or perform without changing the connections. [. . . ]