User manual KORG NANOPAD

[. . . ] On the X-axis, values will be smaller at the left and greater at the right. On the Y-axis, values will be smaller at the bottom and greater at the top. Reverse The high and low values will be inverted. [. . . ] If you're using Microsoft Windows XP/Vista, the USB-MIDI driver that is automatically installed will not allow you to use the nanoPAD with multiple applications simultaneously. If you want to use the nanoPAD with multiple applications simultaneously, you will need to install the Korg USB-MIDI driver. Even if you don't need to use the nanoPAD with multiple applications simultaneously, we recommend that you install the Korg USB-MIDI driver for more stable operation. You can download the Korg USB-MIDI driver from the Korg website, and install it as described in the included documentation. (URL= http://www. korg. com/) If you want to use the Korg Kontrol Editor, you'll need to install the Korg USB-MIDI driver. MIDI Channel [1. . . 16/Global MIDI Channel] This specifies the MIDI channel of the MIDI messages transmitted when you strike the trigger pad. If you set this to "Global MIDI Channel, " the messages will be transmitted on the global MIDI channel. Restoring the factory settings If you turn on the power while holding down the [HOLD] button, [FLAM] button, and [SCENE] button, the settings of the nanoPAD will return to their factory-set condition, and the scene LEDs will light. The process of restoring the factory settings will take several seconds after you turn on the power. You must not turn off the power during this time. X-Y pad operations X-axis Y-axis Controls the speed of the roll. Moving toward the left edge of the X-Y pad will slow down the roll, and moving toward the right edge will speed up the roll. Controls the volume (velocity) of the roll. Moving toward the bottom edge of the X-Y pad will decrease the velocity values, and moving toward the top edge will increase the velocity values. Assign Type [No Assign/Note/Control Change] This specifies the type of message that will be assigned to the trigger pad. You can disable the pad (no assignment), or assign a note message or a control change. 4. [FLAM] button Press this to turn the Flam function on/off. Pad Behavior [Momentary/Toggle] You can choose one of the following two types of behavior for the trigger pad. Momentary The Note On or On Value will be transmitted when you press the trigger pad, and the Note Off or Off Value will be transmitted when you release it. Toggle The Note On or On Value will be transmitted alternately with the Note Off or Off Value each time you press the trigger pad. Troubleshooting Power does not turn on - If you're using a passive (non-powered) USB hub, the nanoPAD may fail to power-on because it is not getting enough power. If this is so, connect the nanoPAD to a powered USB hub or directly to your computer. What's the Flam function? This function simulates the drumming technique in which the sticks held in both hands strike a drum nearly simultaneously, with just a slight gap in timing. Driver ports The nanoPAD's USB-MIDI I/O will be seen from the computer as 1IN-1OUT. [. . . ] You can set this only if the assign type is "Control Change. " Y-axis Roll/Flam Enable [Disable/Enable] MIDI IN port This is where MIDI messages from the nanoPAD's various controllers are received. If you want to use the nanoPAD to control an application on your computer, then select this port in the MIDI input settings of your application. This is also used by the Korg Kontrol Editor to control the nanoPAD. [. . . ]