User manual KORG PA800

[. . . ] When connecting a SECAM-compliant TV set, select the PAL standard. However, in this latter case, the image will be shown in black and white. Precautions / Précautions / Warnhinweise / Precauzioni • Installation of the card is done at the user’s own risk. [. . . ] Remove the protective stopper (f) by pushing it from inside the slot. After having opened the cover (e), unfasten the power cable (i) by removing the screw (g) and the clip (h). Be very careful not to let the power cable (i) fall inside the instrument. Attach the cover (e) to the circuit board (a) by using the four previously removed screws (b). Connect the power cable (i) to the circuit board (a), as shown in the illustration. Replace the cover (e) to the original position, being very careful to make the protruding side of the circuit board (a) slide in before any other side. Slide the cover (e) up to the original position. The video connector protruding from the circuit board (a) will pass through the corresponding hole on the back of the instrument. Attach the cover (e) to the bottom of the instrument by using the four previously removed screws (d). 4 Installation / Montage / Montage / Installazione For installation, you will need a cross-point screwdriver (not supplied). On the back of the instrument, unscrew the two screws (a) and extract the cover (b), to gain access to the video slot. Fully remove the cover (b) by unfasteing the ground cable (c). Be very careful not to let the ground cable (c) and the attached power cable (d) fall inside the instrument. Extract the video card (e) from its package, being careful not to touch any component on its surface with your fingers. [. . . ] The Write Global-Global Setup dialog box will appear. Turn the television set on, and tune it on the AV1 or AV2 input. Turn the instrument on, and press the GLOBAL button to gain access to the Global edit mode. [. . . ]