User manual KORG PADKONTROL

[. . . ] Making connections and turning on the power . 15 Using your computer to manage scene sets . Using the unit in the following locations can result in a malfunction. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. [. . . ] trigger pads [1]­[16] correspond to scene numbers 1­16. For details on how to recall a scene, refer to "Recalling a scene" (p. Press a trigger pad to which a snare drum or similar sound is assigned. Even if the [ROLL] key is on, you can't play a roll unless your finger is on the X-Y pad. You can save (write) the settings currently assigned to each controller as a "scene. " For details on how to save a scene, refer to "Saving a scene" (p. Eight frequently-used MIDI messages are assigned to trigger pads [09]­[16]. You can use these shortcuts to quickly change the MIDI messages that are assigned to the X-Y pads or assignable knobs 1/2. Hold down the [X] key if you want to assign a message to the X-axis of the X-Y pad, the [Y] key for the Y-axis, the [KNOB 1 ASSIGN] key for assignable knob 1, or the [KNOB 2 ASSIGN] key for assignable knob 2; then press the trigger pad [9]­[16] for the MIDI message that you want to assign. The MIDI message you selected will be assigned to the controller you selected. In Setting mode you can edit the scene parameters (controller assignments and settings) for the padKONTROL's controllers, and set the parameters for the Flam and Roll functions. Press the [SETTING/ENTER] key to enter Setting mode. If you want to return to Play mode at this point, press the [SETTING/ENTER] key again and the key will go dark. While you're making an assignment or choosing a setting, the [SETTING/ENTER] key will be lit and the display will be blinking. When you then press the [SETTING/ENTER] key, the setting will be applied and you will return to Play mode. If you decide to cancel the change you made, press the [MESSAGE/EXIT] key. If you want to set another parameter, skip this step. If you are done, press the [SETTING/ENTER] key. The setting will be applied, and you will return to Play mode. The [SW TYPE/POLARITY] key will light, and the display will indicate the switch type. You can specify the note number, MIDI transmit channel, switch type, and velocity of the note message that will be sent when you press the trigger pad. If you want to keep the changes you made, you must save them. [. . . ] 21­26) specifies the port to which the messages are input. If you're using the padKONTROL to control an application on your computer, select one of these ports in the MIDI Input settings of your application. The MIDI messages transmitted by the software are sent without change to the padKONTROL's MIDI OUT connector. If you're using the padKONTROL as a USB-MIDI interface (for example when sending MIDI messages from a computer application to an external device), select this port in the MIDI output settings of your application. [. . . ]