User manual KORG PITCHJACK

[. . . ] Notice regarding disposal (for EU) If this “crossed-out wheeled bin” symbol is shown on the product or in the operating manual, you must dispose of the product in an appropriate way. Do not dispose of this product along with your household trash. By disposing of this product correctly, you can avoid environmental harm or health risk. The correct method of disposal will depend on your locality, so please contact the appropriate local authorities for details. [. . . ] If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. WARNING: Use of this product in any country other than that for which it is intended could be dangerous and could invalidate the manufacturer’s or distributor’s warranty. Please also retain your receipt as proof of purchase otherwise your product may be disqualified from the manufacturer’s or distributor’s warranty. CALIFORNIA USA ONLY This Perchlorate warning applies only to primary CR (Manganese Dioxide) Lithium coin cells sold or distributed ONLY in California USA. € This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 8 6 Gently press the battery cover on the back of the GB-1 with the side of your thumb and turn the cover counterclockwise to remove it. Install the battery so that the positive (+) side of the battery is facing up. Turn the battery cover clockwise to reattach it. As the battery runs down during operation, the string name indicator LED will blink and the LED meter will not operate smoothly, resulting in inaccurate tuning. When this occurs, install a new battery as soon as possible. You must remove the GB-1 from the instrument and turn off the power before replacing the battery. The included battery is for verification of operation, and may have a shorter lifespan than usual. If the battery become unusable, remove them immediately. You should also remove the battery if you won’t be using the tuner for an extended period of time. Insert the 1/4” connector into your guitar/bass output jack and adjust the position of your instrument so that the display can easily be viewed. Always hold the part just above the input plug as shown in the diagram when you install or remove the GB-1 from your instrument. If you hold the GB-1’s body and insert it into the input plug, the hinge section may become damaged. [. . . ] When you press the [FLAT/LIGHT] switch while the current flat setting is displayed, the setting will change. While in the flat tuning mode, the flat mode LED blinks. If you do not press the [FLAT/LIGHT] switch for about one second, or if the [POWER] switch is set to STANDBY the tuner defaults to standard tuning mode. Once the desired number of flats is selected, tune your instrument accordingly. [. . . ]