User manual KORG SOS

[. . . ] 2. You can monitor your input level from the condenser mic by watching the level meter in the LCD screen. To adjust the input level, while in Standby mode, press the Menu button to access the Menu page. Use the right controller button and keep scrolling to the right until you access Level Control. 3. The recording level is appropriate if the level meter stays around “-6”, and the Clip LED indicators do not light up when loud audio is input. [. . . ] You can do this an infinite amount of times. Cancelling recording (Undo/Redo) You can use the Undo function to cancel your recording. To cancel the Undo operation, use the Redo feature. You can set the Undo/Redo function to Undo 1 time, 10 times, or an infinite amount of Undo. For the simplicity of this EasyStart manual, we will keep the amount of Undo to 1 time, as this is the SOS factory default setting. 1. Press and hold the UNDO/REDO button, then, while holding down the UNDO/REDO button, press the left controller button, after recording. 2. The unit discards the latest recording and reverts to the status prior to recording the discarded track. 3. To cancel Undo, press and hold down the UNDO/REDU button again, and while holding it down, press the right controller button while the Undo LED indicator is illuminated. Hot Tip: Setting Undo to a higher number and setting the default for Undo from Delete to Keep allows you to keep your history of takes and undo’s so you can comp vocals and try out different solos, reassembling them later in your DAW. To learn how to make these setting changes see the Owner’s Manual pgs. 31-32. Turning the effects on or off 1. Press the FX button to turn the effects on. 2. Press the FX button again to turn the effects off. 1. To set the loop, locate the loop start point (Point A) by playing up to the location you want, then press the A/B SET button. Point A is marked and the loop LED indicator will flash. 2. Locate the loop end point (Point B); press the A/B SET button. Point B is marked and the loop LED indicator will light up steadily. To cancel the setting, press the A/B SET button again. The loop LED indicator will turn off and Points A and B are erased. 3. Press the A/B LOOP button to turn on the A/B Loop function. Start playback, when the playback position reaches Point B, it automatically returns to Point A to repeat A/B playback. 5. Press the A/B LOOP button again to turn the A/B Loop function off. Finalizing procedure Note: The track files are BWF (Broadcast Wave Format), so they are time stamped. You only need to perform the finalizing procedure if your DAW does not support BWF, or for when you want to burn a CD. 1. Access the FINALIZE page, then use the plus/minus controller button to select one of the following options: MATERIAL, 2MIX and BOTH. [. . . ] 1. Press the Record button to enter Record Ready mode. 2. Press plus/minus on the controller button to adjust the input level. You can also use the touch slider displayed on the LCD to adjust the level. 3. To adjust the input level, while in Standby mode, press the MENU button to access the Menu page. [. . . ]