User manual KORG SP170

[. . . ] DIGITAL PIANO Owner’s manual Manuel d’utilisation Bedienungsanleitung MIDI implementation chart E F G 1 Precautions Location Using the unit in the following locations can result in a malfunction. € In direct sunlight • Locations of extreme temperature or humidity • Excessively dusty or dirty locations • Locations of excessive vibration • Close to magnetic fields THE FCC REGULATION WARNING (for USA) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] For such connections, use commercially-available cables that are appropriate for the components. Before connecting audio components, make sure that you turn off the power to the unit and the audio components. Otherwise, damage or malfunction to the unit or components may occur. – Using the music stand • Insert the legs of the supplied music stand into the dedicated groove located in the middle of the top panel. While simultaneously pressing and holding down the A#7, B7, and C8 keys (at the right end of the keyboard), press one of the keys ranging from C7 to A7. The preset sound assigned to the key that you pressed will be selected. Whenever you turn on the power to the unit, the default preset sound (Piano 1) will be recalled. Piano 1: Piano 2: Elegant and warm grand piano Clear and bright grand piano Smooth, authentic electric piano Modern, percussive electric piano Classical harpsichord Expressive electric clavichord Smooth vibraphone Pipe organ Drawbar electronic organ Ensemble string section Press these simultaneously E. Play back the demo songs to discover rich and expressive sounds. While pressing and holding down the A#7, B7, and C8 keys (at the right end of the keyboard), press one of the keys ranging from C6 to A6. The demo song assigned to the key you pressed (as shown below) will start playing. Playback starts from the selected song, then continues and repeats all demo songs in ascending order until you stop the playback. To stop the playback of the demo song, press the A#7, B7, and C8 keys simultaneously. Organ) : Demo 10 (Strings) : 1 3 5 6 8 10 Using a Damper Pedal You can use the supplied pedal as a damper pedal by connecting it to the [DAMPER SW] jack on the rear panel of the unit. While you press the pedal, the sound will sustain, creating a rich, lingering sound. Alternatively, you can use an optional DS-1H damper pedal. a half-pedal damper effect can be applied to Piano 1 or 2. Damper switch jack 4 Using Other Functions About the confirmation sound When you press and hold down the A #7, B7, and C8 keys simultaneously at the right end of the keyboa rd, or you pr e s s a key where a f unct ion has been assigned, you will hear the confirmation sound. You can turn this sound off, as described below. While simultaneously pressing and holding down the A#7, B7, and C8 keys, press the A# 0 to turn off the confirmation sound. To turn on the confirmation sound, repeat the previous procedure but press the B0 instead of A# 0. The default setting (when you turn on the unit) is "Confirmation sound On. [. . . ] The default setting (when you turn on the unit) is ENA (transmitted) for both Program and Control Change messages. CC0: Ba n k Select (MSB) for each sound is assigned to 121. Heavy G ENA ENA G A A B C C D D E F DIS G3 A3 2 1 3 4 5 6 7 Key Touch Confirmation sound On/Off B0 C1[24]* C2[36]* D2 E2 F2 Transpose (F 2–F3) C3[48]* 8 MIDI C4[60]* 6 Enabling/Disabling Enabling/Disabling Program Change Control Change transmission transmission A3 B3 Troubleshooting If you suspect any malfunction, check the following suggestions. If the problem persists, contact your nearest Korg distributor. [. . . ]