User manual KORG SP300

[. . . ] Location Using the unit in the following locations can result in a malfunction. The CE mark that is attached to our company's products of AC mains operated apparatus until December 31, 1996 means it conforms to the EMC Directive (89/336/EEC) and to the CE mark Directive (93/68/EEC). The CE mark that is attached after January 1, 1997 means it conforms to the EMC Directive (89/336/EEC), to the CE mark Directive (93/68/ EEC) and to the Low Voltage Directive (73/23/ EEC). In addition, the CE mark that is attached to our company's products of Battery operated apparatus means it conforms to the EMC Directive (89/336/ EEC) and to the CE mark Directive (93/68/EEC). [. . . ] Note: Effect settings made in Single mode are memorized even when selecting the Layer mode, but no change made in Layer mode will be preserved. When the instrument is turned on, the effect settings are reset to the factory settings. To save these settings, save them using the Data Dump function (see "MIDI Data Dump" on page 30). Hold down the REVERB or CHORUS button, and press either the PIANO 1/L, PIANO 2/M, or E. To check the currently selected reverb or chorus depth, hold down the REVERB or CHORUS button, and look at which of the above LEDs is turned on. To turn the reverb or chorus off, press the REVERB or CHORUS button. The supplied pedal can be used as a damper pedal. If you connect to the DAMPER jack a Korg DS1H pedal (optional), you can use the half-pedalling, with a gradual resonance effect depending on the depth of the pedal pressure. in Layer mode , you can select the sound(s) to apply the pedal to. Note: When the instrument is turned on, the pedal settings are reset. To save these settings, save them using the Data Dump function (see "MIDI Data Dump" on page 30). Note: When the instrument is turned on, the bell is automatically disabled. The keyboard sensitivity, or touch, can be programmed. Keep the TOUCH button pressed, and press the appropriate button to select one of the available touch settings. Loud notes can be produced even by playing lightly. Loud notes can be produced only by playing very hard. Strong Playing strength To check the currently selected setting, hold down the TOUCH button, and look at which of the above LEDs is turned on. Note: When the instrument is turned on, the touch setting is reset to Normal. Alternatively, you can use the TRANSPOSE/FUNCTION button and the keyboard. Hold the TRANSPOSE/FUNCTION button, and press the key on keyboard that corresponds to the touch setting you wish to carry out (see table). Loud notes can be produced even by playing lightly. Loud notes can be produced only by playing very hard. [. . . ] (3) Make sure that the MIDI Local function is not set on OFF. If it is, set it to ON (or turn the instrument off and then on again). The SP-300 contains sampled sounds, which have been recorded, analyzed and processed from the actual sounds of the original musical instruments. These sounds usually consist of one or more different samples reproduced by pressing a key. [. . . ]