User manual KORG X50

[. . . ] Operation Guide E1 Precautions Location Using the unit in the following locations can result in a malfunction. · · · · · In direct sunlight Locations of extreme temperature or humidity Excessively dusty or dirty locations Locations of excessive vibration Close to magnetic fields THE FCC REGULATION WARNING (for U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The other pages let you modify the sound in more detailed ways. · Select and play combinations. · Select a program for each timbre, and set status, pan, and level. (Same as the 1: Ed­ Tone Adjust parameters; can be edited from either page. ) · Select an arpeggio pattern and make settings. · Select a program for each timbre, and set status, pan, and level. · Use Tone Adjust to adjust parameters. · MIDI, OSC, Pitch, Delay, and Scale settings for each timbre. · MIDI message transmission/reception filter settings for each timbre. · Key zone settings for each timbre. · Velocity zone settings for each timbre. (Same as the 0: Play parameters; can be edited from either page. ) · Controller settings. · BUS and master effect send level settings for each timbre. · Insert Effect routing, selection, and settings. · Master Effect selection and settings. · Master EQ settings. You can select a program for each timbre in the COMBI 0: Play, Prog page or in the COMBI 1: Ed­ Tone Adjust, Prog page. For the procedure, see "Changing the programs within the Combination" (p. 60) Status and MIDI settings "Status" and MIDI channel Status This controls the status of MIDI and the internal tone generator for each Timbre. Normally, if you're playing an internal Program, this should be set to INT. If the status is set to Off, EXT, or EX2, that internal sounds will not be played. Off simply disables the Timbre entirely. The EXT and EX2 settings allow the Timbre to control an external MIDI device. 1: Ed­Tone Adjust 2: Ed­Timbre Param 3: Ed­MIDI Filter1 4: Ed­MIDI Filter2 5: Ed­Key Zone 6: Ed­Vel Zone 7: Ed­Arp/Ctrls Bank Select (when status=EX2) When the Status is set to EX2, these parameters allow you to transmit MIDI Bank Select messages for changing banks on external MIDI devices. 8: Ed­InsertFX 9: Ed­MasterFX MIDI Channel Timbres that you wish to play from X50's keyboard must be set to the global MIDI channel. Your playing on the keyboard is transmitted on the global MIDI channel, and will sound any timbre that matches this channel. When this is set to Gch, the MIDI channel of the timbre will always match the global MIDI channel, even if you change the global MIDI channel. On some preloaded combinations, Timbres used by arpeggiator may have their MIDI Channels set to something other than Gch. [. . . ] Check the X50's assignments and USB-MIDI port settings. The connected device or software may not support the messages you are transmitting. See the owner's manual of the connected device or software to verify that it responds to the messages you are transmitting. When using USB, sound processing is slow, or the tempo is unstable Is the MIDI driver installed for the USB port you've connected? The driver must be installed for each USB port you use. [. . . ]