User manual KRESS 108 ABL

[. . . ] Action for working with the device, start with light pressure and increase the pressure slowly until the desired operation is achieved. General safety instructions for power tools wARNING!Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] Use appropriate detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Contact with electric lines can lead to fire and electric shock. damaging a gas line can lead to explosion. Penetrating a water line causes damage to property or electric shock. Switch the power tool off immediately if the tool insert gets jammed. be prepared for high torque levels if the tool kicks back. The tool insert jams if: the power tool becomes overloaded or the tool tilts in the workpiece To mark the machine, do not drill into the housing. The effects of noise can cause loss of hearing capacity. Operate the machine only with the auxiliary handle Loss of control can cause personal injury. Always assume a safe standing position and hold the power tool securely in both hands. when the drill unexpectedly jams , the machine kicks back. Operation This may significantly reduce the exposure level over the total working period. 1st n0 = Idle speed (1st gear) 2nd n0 = Idle speed (2nd gear) 1st n1 = Load speed (1st gear) 2nd n1 = Load speed (2nd gear) in rpm Number of impacts n-1 Before carrying out any work on the EN machine, pull the main plug. Before putting into operation, check that the mains voltage and frequency on the identification plate match the details of your mains supply. Fit the additional handle Connect mains cable module if necessary If using an extension cable: Only use extension cables specifically approved for the application with the required cross-section. Otherwise the power of the tool can be reduced and the cable can overheat. Operate the machine only with the additional handle Loss of control can lead to injury. Place the additional handle 2 in the working position to provide a safe and fatigue-free working situation. Tighten the lower hand grip of the additional handle 2 by turning in clockwise direction. Turn the hand grip in anticlockwise direction to release it. Depth setting The required drilling depth X can be set by using the depth stop 3. Release the additional handle 2 and insert the depth stop 3 into the additional handle. [. . . ] Do not dispose of electric tools together with household waste mateEN rial!In observance of the European Directive 2002/96/EC for waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. Before carrying out any work on the machine, pull the main plug. always keep the machine and ventilation slots clean. [. . . ]