User manual KRESS 1100 BMH MAX

[. . . ] With light pressure on the on/off switch 6, the machine begins to rotate slowly; with increased pressure, the speed increases. rOTATIONAL DIRECTION SWITCHING Operate the rotational direction switch 9 only when the machine is at a standstill!Take hold of the rotational direction switch 9 on both sides. If the rotational direction switch 9 is set between the positions "R" and "L", the machine cannot be switched on. [. . . ] Before any work on the machine itself, pull the mains plug!Use the mains cable module provided only for Kress Electro-Tools. Do not attempt to operate other machines with the module. Use only an original Kress mains cable module that is at least of heavy rubber sheathed cable (Code designation H07 RN-F). Check before putting into operation that the mains voltage agrees with the voltage specified on the nameplate of the machine. The on/off switch can be locked on with the locking button 5. To release, briefly press and release the on/ off switch 6. STOP ROTATION Two settings can be selected with the stop-rotation switch 4. The gear switches to the preselected setting after actuating the on/off switch 6, respectively when the machine starts running. Only after the on/off switch 6 is actuated and the machine starts does the gear box shift to the selected mode. When hammer drilling, use exclusively drills with hard metal inserts and SDS-Plus shafts. Screw the drill chuck onto the adapter and lock the adapter in the same manner as a drill in the tool holder. Before any work on the machine itself, pull the mains plug! always keep the ventilation slots clean. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. After heavy use over a long period, the machine should be taken to a Kress service location for an inspection and thorough cleaning. Do not drill into hidden electrical lines or gas and water pipes. Check the area to be worked with a metal detector, for example, before starting. For metal, use only flawless, sharpened drills; for stone and concrete, only masonry drills with hard metal inserts. Always adapt the speed to the material to be worked and the diameter of the drill. For precision working with metal and wood, place the machine in a drill stand (accessory). Do not dispose of electric tools together with household waste material! [. . . ] Do not dispose of electric tools together with household waste material!These instructions are printed on recycled paper manufactured without chlorine. the plastic components are labelled for categorised recycling. Subject to change without notice CE Declaration of conformity We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: see CE Technical file at: see TF This electro-tool was manufactured with high precision and subjected to rigorous factory quality controls. [. . . ]