User manual KRESS 1400 HKS

[. . . ] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 On-off switch with lock off safety position Switch release Auxiliary handle Star grip bolt for parallel stop Parallel stop Clamp lever (for setting the cutting angle) Clamp lever (for setting the cutting depth) Scale for setting the cutting depth Mains cable with patent quick-action lock Lock for mains cable module Swing guard Gap rudder Hex key Base Sawdust ejector (suction neck) Socket head bolt for gap rudder Gap rudder adapter Saw blade Pin for spindle lock Flange Washer Thrust washer Cylinder bolt Cutting depth indicator When inserting the blade, make sure that the direction of the arrow on the blade corresponds to the arrow on the housing. the bearing surfaces of the blade , flange , and washer must be clean. Press and hold down the pin for spindle lock (19) and if necessary rotate the blade until the lock snaps into place. Tighten the cylinder bolt with hex head socket (23) with the hex key (13) with the pin (19) pressed down. [. . . ] 3 Safety instructions about the functioning of the safety equipment · Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position. If saw is accidentally dropped, lower guard may be bent. Raise the lower guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut. If the guard and the spring are not operating properly, they must be serviced before use. Lower guard may operate sluggishly due to damaged parts, gummy deposits, or a build-up of debris. Lower guard should be retracted manually only for special cuts such as "plunge cuts" and "compound Further safety instructions according to 60745-2-5 2. 1 Safety instructions for handling · Keep hands away from cutting area and the blade. keep your second hand on auxiliary handle , or motor housing. If both hands are holding the saw, they cannot be cut by the blade. The guard cannot protect you from the blade below the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece. Never hold piece being cut in your hands or across your leg. secure the workpiece to a stable platform. It is important to support the work properly to minimize body exposure, blade binding, or loss of control. Hold power tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. When ripping always use a rip fence or straight edge guide. This improves the accuracy of cut and reduces the chance of blade binding. Always use blades with correct size and shape (diamond versus round) of arbour holes. Blades that do not match the mounting hardware of the saw will run eccentrically, causing loss of control. [. . . ] These instructions are printed on recycled paper manufactured without chlorine. the plastic components are labelled for categorised recycling. Specifications may be changed due to technical refinements. Consignes de sécurité et protection contre les accidents Avant de mettre la machine en service, lire entièrement la notice d'utilisation, observer les consignes de sécurité énoncées dans cette notice ainsi que les consignes de sécurité générales s'appliquant aux outils électriques, citées dans la brochure ci-jointe. [. . . ]