User manual KRESS 144 AS

[. . . ] The symbols used in these instructions and, if applicable, on the power tool serve to bring your attention to potential dangers when working with this power tool. You must understand the significance of these symbols/notes and comply with them in order to make its use more efficient and safer. The safety warnings, notes and symbols are not a substitute for regulation measures for accident prevention. -WARNINGFor a potentially dangerous situation which could lead to physical injury or material damage. [. . . ] Read all the warnings and instrucEN tions before using the equipment. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. for a clearer understanding , please consult the enclosed illustrations showing the device. Have these illustrations to hand and open while reading the operating instructions. Device description The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to underestimation of vibration when the tool is used regularly in such a manner. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually when doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and accessories, keep the hands warm, organisation of work patterns. Torque soft joint Noise levels LpA = A-rated sound pressure level = A-rated sound power level LwA K = Measurement uncertainty value The noise level can exceed 85 dB(A) during operation. Triaxial vibration emission level determined in accordance with EN 60745. EN ing screws as well as for drilling wood, metal, ceramics and plastic. The personnel must be made aware of the relevant dangers. Remove the battery from the device before undertaking any work on the EN device. This safety measure prevents accidental starting of the power tool. -WARNINGUse only original KRESS batteries with the voltage given on the type plate of your machine. Use of any other batteries may lead to the risk of injury or fire. use only the battery chargers and batteries listed in the illustrated instructions. Because of the danger of self-discharging, NiMH batteries should be stored at ambient temperatures of between 0°C and 25°C where possible. Battery care Never charge batteries at temperatures lower than 5°C or higher than 45°C. Never charge batteries in an environment with high air humidity or a high ambient temperature. [. . . ] It has effective protection against internal overpressure and short circuiting as well as devices for the prevention of violent rupture and dangerous reverse current flow. the lithium-equivalent content in the battery is below applicable limit values. Therefore, the battery is not subject to national or international regulations pertaining to dangerous mediums, neither as an individual component nor when inserted into a machine. However, the regulations governing dangerous goods may be relevant when transporting several batteries. [. . . ]