User manual KRESS 1600 HLG E

[. . . ] Put the hotair blower away in such a way that the still warm blow-out tube does no harm. If the motor fails, switch the hot-air blower off immediately, as otherwise heat accumulates inside it. do not impair the air suction or the hot-air outlet. [. . . ] To switch off again after continuous operation simply press locking button once again and it springs automatically up again. Setting the temperature The temperature is set by means of a rotary potentiometer (6), the range of which is marked by the numbers 1­6. The numbers are identical with the approximate working temperature, e. The hot-air blower produces constant hot air only after a few minutes operation, as all elements must first be heated up or in the case of temperature reduction, first cooled down. Horizontal operation The support (7) for horizontal operation can be locked in place by pulling it out until it catches. By pressing down the pull-out support slide in the housing, the support can be pushed back into the housing again. mains cable Damaged mains cables must not be used. They are to be replaced immediately by an electrician. In the interests of technical progress, all data are subject to alteration without notice. Some sample applications Paints and enamels can be cleanly removed with the aid of a spatula (potentiometer position 3­6 as required). Frozen water pipes can be thawed without damage (temperature may be adjusted as required). Take care when working near wooden walls and wooden false ceilings. increased danger of fire or smouldering fire!Removing wallpaper with the aid of hot air, especially useful in the case of ingrain wallpapers. [. . . ] Details of the various toll wear parts can be obtained from http:// spareparts. The warranty may only be enforced when defects are reported without undue delay (including shipping damage). If you need to apply the warranty, send the original purchase receipt together with the device to us or to the relevant service centre. [. . . ]