User manual KRESS 6066

[. . . ] The distance to the toothed rim of the blade must not exceed 5 mm. The circular saw is now ready for operation. Double insulation Our equipment is designed in accordance with class II EN 50144 (VDE 0740, DIN 66069, VBG 7j) for the utmost safety of the user. Machines with double insulation always carry the international symbol. [. . . ] Of course the cut depth for rectangular cuts would in this case only be 59. Observe proper usage of the circular saw: Cutting wood and wood-like substances with circular blades only. Sockets outside must be protected with a differential-current switch. The casing may not be drilled through to identify the machine. Before using the machine for the first time Before starting the saw, check that the mains voltage is the same as that on the type plate of the device. Safety switch with lock off safety position Before activating the on/off switch (1) in the hand grip, the switch must be unlocked by pressing the switch release (2). Only then can the machine be switched on by pressing the on/off switch. Fixing the on/off switch for prolonged operation is not possible for safety reasons. When the on/off switch is released the power supply is interrupted and the machine comes to a halt. the switchon block automatically blocks the switch thus preventing unintentional activation of the machine. Motor The strong universal motor has the power reserves you need. it is cooled by an extra large fan unit. Prolonged heavy duty may overheat the motor!Allow the motor to cool down in no-load speed! the prevents the motor from overheating. Cleaning procedure and maintenance Long motor life will be your reward when you make the minor effort of blowing the sawdust out of the ventilation openings in the housing after each job, since optimum ventilation is a critical factor in motor life. From time to time, clean the resin deposits out of the sawdust ejector (please do not use caustic cleaning agents). This will ensure proper sawdust ejection. The saw motor is permanently lubricated and so needs no special maintenance. However, if you use the saw for heavy-duty jobs over a long period of time we recommend that you occasionally send it to our service department for This will save you money for repairs and increase the service life of your tool. Base The base (14) has been set in the factory so that it makes an angle of exactly 90° with the blade in basic position (zero mark on scale). 4 point mounting for no twist accurate operation. [. . . ] We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: EN 50144, HD 400, EN 55014-1, EN 55014-2, EN 61000-2-3, EN 61000-3-3 according to the provisions of the regulations 73/23/EEC, 89/336/EEC, 98/37/EC. This electrical tool has been designed with high precision and was approved after undergoing strict quality control checks in the factory. We are therefore able to guarantee free servicing of any production or material faults which arise in the 24 months after the date of sale to the purchaser. We reserve the right to repair defective parts or else replace them with new parts. [. . . ]