User manual KRESS 6165 A

[. . . ] Push dust bag (5) with catch (4) onto seat on fan flange from handle side and press down. Empty the dust bag when suction begins to drop off. The dust bag must be emptied more frequently when sanding plaster. To do this, pull off clamp (6) in direction of arrow and push it back into position after emptying the dust bag. [. . . ] Do not work with materials containing asbestos!Outside power sockets must be protected with residual-current-operated circuit-breakers (r. Do not drill holes into the housing to label the machine. Double insulation Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the international symbol. The machines are interference-suppressed in accordance with EN 55014. Wrap the abrasive paper around the sanding shoe, place it under the second clamp and tighten. ensure that the abrasive paper is clamped as smoothly as possible. Operating Orbital Sander Best results are obtained from the orbital sander by sanding one path after the other. it is recommended to overlap paths slighty. Begin with a rough abrasive paper and continue through the fine grades until the surface finish desired is obtained. Only guide the sander across the surface with just slight pressure. Heavy pressure on the machine is not recommended. A high working pressure reduces the number of orbits, and consequently the sanding capacity. The machine should be running before it is placed on the workpiece and switched off again after it has left the workpiece (this prevents scratches as motor dies out). Maintenance and Upkeep Any tool used work with wood will be covered with dust. This is why thorough upkeep is essential. Keep the motor cooling openings free of dust and dirt. All moving parts of the machine receive sufficient lubrication before leaving the factory. the vibration sander is practically maintenance free. Replacing carbon brushes Our service personnel will carry out this and other servicing work fast and professionally. mains cable Damaged cables may not be used. [. . . ] Parts which have been replaced become our property. The guarantee will be rendered void if the device is used improperly, mistreated or opened up by unauthorised repair personnel. Parts which are subject to wear are not covered by the guarantee. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]