User manual KRESS 650 BS

[. . . ] Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control. Electrical safety Power tool plugs must match the outlet. Do not use any adapter plugs with earthed (grounded) power tools. [. . . ] English 17 Tools not in use must be locked away safely in a dry place out of the reach of children. Dust from light alloys can burn or explode. Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. Although this information sheet and the operating manuals for our electrical tools contain extensive instructions on safe working with electrical tools, every electrical tool involves certain residual risks that cannot be completely prevented through safety mechanisms. Therefore, electrical tools must always be operated with the necessary caution. Read all the warnings and instructions before using the equipment. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. While reading the operating instructions, unfold the graphics page for the machine and leave it open. Jig saw V~ Nominal voltage Watt Input power Watt Output power 340 650 650 BS 230 Min-1 Idling speed stroke number n0 min-1 Standard stroke range mm Stroke height 10 Stop lever 11 Mains cable module 12 Interlock button 13 Chip-flyoff guard (plastic) 14 Sliding block 15 Chip-flyoff guard (steel) 16 Plastic cap (insulated gripping surface) 17 Handle (insulated gripping surface) Scope of supply See packaging Cutting capacity, max. In wood non alloy steel mm light metal mm 6 16 mm 110 19 The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber while resting firmly on the workpiece. Push the two unlocking buttons 13 and remove the mains cable module 12 from the handle. Use only an original Kress mains cable module and at least a heavy rubber tube cable (H07RNF). Miter cuts up to 45° Turn the stop lever 10 90° to release the saw bench 4 at the front. You can now push the saw bench 4 to the back (towards the suction connection piece) and bring it into the desired tilted position. Turn the stop lever 10 back to lock the tilted position. You may need to regulate the tension by turning the lever 10 forwards again and tightening the tension wheel by turning it clockwise. Turn the lever 10 back to lock the saw bench 4 into position. The angles 15°, 30° and 45° can be securely locked into place on the saw bench 4. Setting for rectangular cuts in 0° position (vertical saw blade) Turn the stop lever 10 90° to release the saw bench 4 at the front. Then the saw bench 4 can if necessary be released from the notches by pulling it backwards, then rotated into the 0° position and locked in again. Lock the position of the saw bench 4 by turning the lever 10 back. [. . . ] The threaded pin of the knobtype handle permits readjustment if a greater downward pressure is required according to material, or if the tip of the threaded pin has been re-ground. Make sure that the counter nut is always well-tightened. -NOTEIn extreme working conditions, conductive dust can accumulate in the interior of the machine when working with metal. the protective insulation of the machine can be degraded. [. . . ]