User manual KRESS 650 SPS

[. . . ] English 15 Work area Keep work area clean and well lit. cluttered and dark areas invite to accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite dust or fumes. [. . . ] The personnel must be made aware of the relevant dangers. Kg 2, 3 Weight Your power tool is double-insulated in accordance with EN 60745; For this reason an earth wire is not required. The device is suppressed against radio and TV broadcasts, in accordance with EN 55014-1 and is immune to disturbances in accordance with EN 55014-2. Noise levels Measured values determined according to EN 60 745. Typically the A-weighted noise levels of the machine are: sound pressure level (LpA) 84 dB (A) 95 dB (A) sound power level (LwA) Measurement uncertainty K=3 dB The noise level can exceed 85 dB(A) during operation. Vibration Triaxial vibration emission level determined in accordance with EN 60745. Jig Saw 650 SPS Cutting wood; ah: m/s² 9, 5 Measurement uncertainty K m/s² 1, 6 Cutting sheet metal; ah: m/s² 9, 3 Measurement uncertainty K m/s² 1, 6 The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to underestimation of vibration when the tool is used regularly in such a manner. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually when doing the job. This may significantly reduce the exposure level over the total working period. Before carrying out any work on the EN machine, pull the mains plug. Before putting into operation, check that the mains voltage and frequency on the identification plate match the details of your mains supply. Connect mains cable module If using an extension cable: Only use extension cables specifically approved for the application with the required cross-section. Otherwise the power of the tool can be reduced and the cable can overheat. If the mains cable is damaged while working, pull the mains plug immediately. Use the mains cable module 12 only for Kress electric tools. Do not attempt to operate other machines with the module. damaged mains cable modules must not be used. They must be replaced by a new Kress mains cable module immediately. Push the two unlocking buttons 13 and remove the mains cable module 12 from the handle. Use only an original Kress mains cable module and at least a heavy rubber tube cable (H07RNF). [. . . ] The use of a stationary extraction system is recommended in such cases as well as frequently blowing out the ventilation slots and installing a residual current device (RCD). Replacing brushes Worn carbon brushes should be replaced by an authorised customer service organisation. After heavy use over a long period, the machine should be taken to a Kress service location for inspection and thorough cleaning. Spare parts / exploded view Exploded views and spare parts lists are available on our home-page http://spareparts. [. . . ]