User manual KRESS 700 PSE

[. . . ] When sanding stairs, the rubber head 8 can be taken off by removing the 4 screws on the rubber head. Mount the auxiliary handle 6 onto the machine especially for doing polishing work. Screw the auxiliary handle 6 onto the right or left side of the machine head, depending on the working mode. Use the mains cable module provided only for Kress Electro-Tools. [. . . ] The electronic overload protection limits the speed if there is danger of the load causing damage to the motor. The load on the machine must be reduced in order for the full capacity to be made available again. This is best done by briefly taking the machine away from the work piece. The thumbwheel 5 enables the optimum speed to be pre-selected, also while running. The speed required will depend on the working material and is determined by trial and error (see application table). Eccentric movement without mechanical coupling: The eccentric movement without mechanical coupling is set when the rocker lever 9 is in position A. An independent rotation is superposed on the vibrations of the backing pad and thereby a furrow-free surface is attained during precision sanding and the sanding sheet is only subject to a minimum amount of wear. Eccentric movement with mechanical coupling: The eccentric movement with mechanical coupling is set when the rocker lever 9 is in position B. Any resistance felt when switching over the rocker lever 9 can be overcome by slightly turning the backing pad. Before any work on the machine itself, pull the mains plug!However, rubber backing pads with varying degrees of hardness may be fitted, depending on the type of application (see application table): Soft rubber backing pad: All-purpose, suitable for all sanding work. Select low speed for polishing (step 1-2) in order to avoid excess heating of surface. Work in the polish, applying moderate pressure, in a crosswise or circular motion and then allow to dry slightly. In order to achieve optimum polishing results, the polishing tools must be cleaned regularly. It is recommended to wash the polishing tools with a mild detergent and warm water (do not use diluting agents). Before any work on the machine itself, pull the mains plug! always keep the ventilation slots clean. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. The rubber seal 13 protects the drive against any dirt and thereby also from increased wear and a shorter service life of the drive parts. The rubber seal must therefore be checked regularly for damage. If the seal is damaged the machine should be taken to a Kress after-sales service station. After heavy use over a long period, the machine should be taken to a Kress service location for an inspection and thorough cleaning. [. . . ] Varvtalet måste anpassas till arbetsmaterialet; du kan prova dig fram till bästa varvtal genom praktiska försök (se användningstabell). Efter kraftig påkänning under en längre period lämna in maskinen till en Kress-serviceverkstad för grundlig rengöring. This electro-tool was manufactured with high precision and subjected to rigorous factory quality controls. Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. [. . . ]