User manual KRESS 750 PSE

[. . . ] Application The 750 PSE flat mortise router can be employed for routing grooves in a range of materials including solid wood, plywood, particle boards, fibreboards, plexiglass and artificial marble with mortise type nos. 0 , 10 , 20 , S6 , H9 , Simplex and Duplex as well as for milling resin pockets in solid wood. Safety rules and instructions which should be read prior to operation. We strongly urge that you always observe them for your own safety. [. . . ] Using the index stop (27), 3 different thicknesses can be preset. This involves loosening the 6kt nut, setting the 6kt screw to the desired scale and retightening the nut. Sawdust exit nozzle and suction nozzle A sawdust exit nozzle (14), a sawdust catch bag (15) and a suction nozzle (16) are part of the accessory kit. The sawdust exit nozzle (14) or the suction nozzle (16) snap into the support shoe (6) to eject the sawdust backwards rather than to the side. The sawdust catch bag (15) can be attached over the suction nozzle (16) so that the sawdust is ejected directly into the bag (15). for operating the router in a shop environment , we recommend attaching a regular vacuum cleaner. In some countries, use of a vacuum cleaner is mandatory when routing oak or beechwood. Turning the router on and off The router is turned on by turning the ring switch (8) in the direction of the arrow. The rocker switch (9) automatically snaps into place if the ring switch (8) is turned all the way. By depressing the raised front edge (10) of the rocker switch (9), the rocker switch is disengaged and the ring switch (8) returns automatically to its OFF position. 2 Marking the groove placement The grooves are usually spaced between 10 and 15 cm apart. clamp the spindle (21) in place by pressing the push plate (20). The flanged nut (22) can be removed using a double-pin wrench. Centre the new routing tool on the flange nut (28) and fasten with the flange nut (22). Turn the routing tool (23) until a cutting tooth (24) has reached the forwardmost point on the circumference. Use a measuring rule to measure the routing depth at the routing tool (23). Tighten the nut (25) to fix at the new setting. Replacing carbon brushes Our service personnel will do this and all other servicing work quickly and professionally. This has been made very straightforward by the new mains cable module (17). Press both locking keys (18) and pull the mains cable module (17) out of the handle. Insert the new mains cable into the handle and lock in place. Different lengthed mains cables are available as special accessories. [. . . ] Lämna tillbaka skrotade Kressmaskiner till affären eller skicka in dem till Kress. This electrical tool has been designed with high precision and was approved after undergoing strict quality control checks in the factory. We are therefore able to guarantee free servicing of any production or material faults which arise in the 24 months after the date of sale to the purchaser. We reserve the right to repair defective parts or else replace them with new parts. [. . . ]