User manual KRESS 800 FDF

[. . . ] English 15 Work area Keep work area clean and well lit. cluttered and dark areas invite to accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite dust or fumes. [. . . ] During operation, always ensure that the mains and extension cable is to the rear away from the device. This prevents anyone from tripping over the cable while working. Move the switch to the "OFF" position before removing the plug from the plug socket. When the tool is reconnected to the mains accidental starting of the machine is avoided, thus reducing the risk of accidents. Use appropriate detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Contact with electric lines can lead to fire and electric shock. damaging a gas line can lead to explosion. Penetrating a water line causes damage to property or electric shock. Tools not in use must be locked away safely in a dry place out of the reach of children. To mark the machine, do not drill into the housing. Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable gets damaged during operation. Although this information sheet and the operating manuals for our electrical tools contain extensive instructions on safe working with electrical tools, every electrical tool involves cerFDF-EN / 0802 18 English tain residual risks that cannot be completely prevented through safety mechanisms. Therefore, electrical tools must always be operated with the EN necessary caution. Read all the warnings and instructions before using the equipment. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Device components 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 Mains cable module Locking button Motor housing Handle Column guide Stop Marks Protective guard Slip protector Locking screw for height adjustment Index stop for height adjustment Lock nut for index stop Stop screw for index stop Scale for height adjustment Ejector adapter On/Off switch Cutting depth thumbwheel Depth stop adjustment Adjusting screw for depth stop adjustment Lock nut for depth stop adjustment Locking screw for angle adjustment Angle scale Spindle lock button Dust collector Adapter Base plate Screws (4x) Cover Two-pin spanner The 800 FDF biscuit jointer is used for routing grooves in solid wood, plywood, particle boards, fibreboards, Plexiglas and artificial marble with biscuit types No. The personnel must be made aware of the relevant dangers. Biscuit Jointer Input power Output power Watt Watt 800 FDF 800 420 No-load speed min-1 11000 Spindle thread M10 Blade, inside Ø mm 22 Routing Ø, max. Mm 100 Routing blade/hub thickness mm 4/3 Cutting depth mm 19 Swivel range 0 - 90° Weight kg 3, 1 Your power tool is double-insulated in accordance with EN 60745; For this reason an earth wire is not required. The device is suppressed against radio and TV broadcasts, in accordance with EN 55014-1 and is immune to disturbances in accordance with EN 55014-2 Before putting into operation, check that the mains voltage and frequency on the identification plate match the details of your mains supply. Before putting into operation, check the cutting disc for tight seating. [. . . ] clean and grease the column guides 5 as required. Replacing brushes Worn carbon brushes should be replaced by an authorised customer service organisation. After heavy use over a long period, the machine should be taken to a Kress service location for inspection and thorough cleaning. This power tool has been carefully tested and has been subjected to a strict quality control process. [. . . ]