User manual KRESS 900 HEX-2

[. . . ] Eccentric disc sander Article number Input power Output power No-load speed No-load oscillations rate Backing pad Ø Eccentric amplitude Ø Weight Safety class Sound pressure level: 78 dB (A) Sound power level: 91 dB (A) Work place emission value: 81 dB (A). For operation, noise protection measures are required. The acceleration measured is usually less than 2. Accessories illustrated or described are not always included as standard delivery items. [. . . ] The machine has its own effective dust extraction facility with integrated suction turbine and dust bag. Push the dust bag with the locking connection 14 from behind onto the mounting on the blower flange and press it on. the locking connection engages by spring pressure. The dust bag can be taken off by pulling the mouldedon grip. The dust bag must be emptied as soon as the suction strength slackens. To do this, pull the clamp off in the direction of the arrow and push it on again after emptying. The machine is fitted with a quick-change (connecting link) system, enabling sanding tools to be changed easily without the aid of an additional tool. Before mounting any new sanding sheets 16, dust and dirt must be removed from the backing pad 12. Press the sanding sheets or polishing tools onto the backing pad and make sure that the bore holes of the sanding sheet match the bore holes on the backing pad. Only use original Kress sanding and polishing tools with the pressure-sensitive connecting link. Only perfect sanding sheets will give a good sanding performance and protect the machine. Less contact pressure gives a better sanding performance and protects the machine and sanding tools. Different rubber backing pads and sanding wheels should be used depending on the material. The abrasive power and the sanding finish are determined primarily by the choice of sanding disc (grain), speed of the rubber backing pad and contact pressure (ssee application table). Place the whole sanding area of the eccentric disc sander onto the material which requires sanding. When changing the backing pad carrier plate 15, pull off the sanding sheet or polishing tool, respectively. Loosen screw 17 with a Torx screwdriver and remove. Hold the backing pad carrier plate 15 firmly and tighten the screw 17 firmly with a Torx screwdriver. The following table should only be used as a recommendation. The most suitable combinations are best determined by carrying out a practical test. [. . . ] We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. Parts subject to wear are excluded from the guarantee. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]