User manual KRESS 900 PSH PLUS

[. . . ] Before any work on the machine itself, pull the mains plug! English 7 Putting into Operation Check before putting into operation that the mains voltage agrees with the voltage specified on the nameplate of the machine. The curved handle can be mounted in 3 positions according to the application and preference of the user. For mounting in the middle on the top of the rubber head please proceed as follows: Position the curved handle with spacer 2 onto the machine such that the screw of the curved handle comes lies over the screw opening on the rubber head. [. . . ] The numbers on the thumbwheel 10 correspond approximately with the following speeds: 1 2 3 4 5 6 4650 RPM 5800 RPM 7000 RPM 8300 RPM 9700 RPM 11000 RPM Continue to unscrew the locking grip anticlockwise until the curved handle can be lifted out of the toothed grid of the spacer. Turn the curved handle to the desired position and allow it to notch in the toothed grid of the spacer. Use the mains cable module provided only for Kress Electro-Tools. Do not attempt to operate other machines with the module. Only use original Kress mains cable modules and at least flexible rubber tube (code designation H05 RR-F). The integrated backing pad brake reduces the number of vibrations at no-load, thus preventing furrows occurring when positioning the machine on the work piece. A steadily increasing no-load speed indicates that the brake ring is worn und must be replaced. Before any work on the machine itself, pull the mains plug!However, rubber backing pads with varying degrees of hardness may be fitted, depending on the type of application (see application table): Super-soft backing pad: Suitable for polishing large surfaces and for particularly sensitive sanding work (also curved surfaces). For long periods of working with wood or for commercial use on materials that produce dust that is detrimental to health, the machine is to be connected to a suitable external dust extraction device. The rubber reducer can be used for reducing the connection diameter on the diameter of the vacuum cleaner tube. Select low speed for polishing (step 1 ­ 2) in order to avoid excess heating of surface. Work in the polish, applying moderate pressure, in a crosswise or circular motion and then allow to dry slightly. In order to achieve optimum polishing results, the polishing tools must be cleaned regularly. It is recommended to wash the polishing tools with a mild detergent and warm water (do not use diluting agents). Before any work on the machine itself, pull the mains plug! always keep the ventilation slots clean. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. The rubber seal 18 protects the drive against any dirt and thereby also from increased wear and a shorter service life of the drive parts. The rubber seal must therefore be checked regularly for damage. If the seal is damaged the machine should be taken to a Kress after-sales service station. After heavy use over a long period, the machine should be taken to a Kress service location for an inspection and thorough cleaning. [. . . ] Efter kraftig påkänning under en längre period lämna in maskinen till en Kress-serviceverkstad för grundlig rengöring. Lämna in din gamla Kress-maskin till återförsäljaren eller skicka den direkt till Kress. This electro-tool was manufactured with high precision and subjected to rigorous factory quality controls. Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. [. . . ]